Injection Actuation Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove injection actuation pressure sensor (2). Remove the O-ring seal from the injection actuation pressure sensor.
Show/hide table
Illustration 1 | g01144602 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the O-ring seal on injection actuation pressure sensor (2).
- Install injection actuation pressure sensor (2) and tighten to a torque of
20 ± 2 N·m (177 ± 18 lb in) . - Connect harness assembly (1).
Show/hide table
Illustration 2 | g01144602 |
Caterpillar Information System:
3516B HD Generator Set Refill Capacities
C9 Marine Engines and C9 Marine Generator Sets Fuel Temperature Sensor - Remove and Install
EMCPII+ for Gas Engines GSC CID 0168 - FMI 04
EMCPII+ for Gas Engines GSC CID 0168 - FMI 03
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Install
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Remove
C9 Marine Engines and C9 Marine Generator Sets Fuel Pressure Sensor - Remove and Install
C11, C13, and C15 On-highway Engines Diagnostic Flash Code Retrieval
C11, C13 and C15 On-highway Engines 0284-06 Engine Coolant Diverter current high (98)
C11, C13 and C15 On-highway Engines 0284-05 Engine Coolant Diverter current low (98)
C11, C13 and C15 On-highway Engines 0283-06 Intake Valve Actuation System Oil Pressure Solenoid current high (97)
C11, C13 and C15 On-highway Engines 0283-05 Intake Valve Actuation System Oil Pressure Solenoid current low (97)
C9 Marine Engines and C9 Marine Generator Sets Inlet Air Temperature Sensor - Remove and Install
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Disassemble
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Assemble
C9 Marine Engines and C9 Marine Generator Sets Speed/Timing Sensor - Remove and Install
EMCPII+ for Gas Engines GSC CID 0190 - FMI 02
2003/03/10 New Terminology is Now Used {7000}
EMCPII+ for Gas Engines GSC CID 0190 - FMI 03
G3520C and G3520E Generator Set Engines Exhaust Elbow - Remove and Install
EMCPII+ for Gas Engines GSC CID 0269 - FMI 03
C7 Urban Transit Bus Engines Caterpillar Driver Information Display - Messenger
3054E Industrial Engine Balancer Group - Install - If Equipped
G3500B Engines Engine Oil Lines - Turbocharger Oil Lines