Inlet Air Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove inlet air temperature sensor (2). Remove the O-ring seal from the inlet air temperature sensor.
Show/hide table
Illustration 1 | g01144632 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 2 | g01144632 |
- Install the O-ring seal on inlet air temperature sensor (2).
- Install inlet air temperature sensor (2) and tighten to a torque of
20 ± 5 N·m (15 ± 4 lb ft) . - Connect harness assembly (1).
Caterpillar Information System:
C9 Marine Engines and C9 Marine Generator Sets Injection Actuation Pressure Sensor - Remove and Install
3516B HD Generator Set Refill Capacities
C9 Marine Engines and C9 Marine Generator Sets Fuel Temperature Sensor - Remove and Install
EMCPII+ for Gas Engines GSC CID 0168 - FMI 04
EMCPII+ for Gas Engines GSC CID 0168 - FMI 03
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Install
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Remove
C9 Marine Engines and C9 Marine Generator Sets Fuel Pressure Sensor - Remove and Install
C11, C13, and C15 On-highway Engines Diagnostic Flash Code Retrieval
C11, C13 and C15 On-highway Engines 0284-06 Engine Coolant Diverter current high (98)
C11, C13 and C15 On-highway Engines 0284-05 Engine Coolant Diverter current low (98)
C11, C13 and C15 On-highway Engines 0283-06 Intake Valve Actuation System Oil Pressure Solenoid current high (97)
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Disassemble
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Assemble
C9 Marine Engines and C9 Marine Generator Sets Speed/Timing Sensor - Remove and Install
EMCPII+ for Gas Engines GSC CID 0190 - FMI 02
2003/03/10 New Terminology is Now Used {7000}
EMCPII+ for Gas Engines GSC CID 0190 - FMI 03
G3520C and G3520E Generator Set Engines Exhaust Elbow - Remove and Install
EMCPII+ for Gas Engines GSC CID 0269 - FMI 03
C7 Urban Transit Bus Engines Caterpillar Driver Information Display - Messenger
3054E Industrial Engine Balancer Group - Install - If Equipped
G3500B Engines Engine Oil Lines - Turbocharger Oil Lines
G3500B Engines Exhaust Manifold