Exhaust Manifold
Show/hide table
图 1 | g01188183 |
3 段式排气歧管(典型示例) |
Show/hide table
注意 |
---|
过多使用密封剂可能导致部件损坏。 为了避免零件损坏,仅使用适量的密封剂。 |
使用以下步骤安装 3 段式排气歧管到缸体。
- 安装面应干净而干燥。 另外,安装面不应有任何异物。
- 将 2P-2333 高温密封胶 涂抹到排气歧管公接口的外径上。 不要在公接口涂抹密封胶。 去除组装好的接头上的多余的密封胶。
- 将 5P-3931 抗咬合剂 涂抹到螺栓 (1) 到螺栓 (12) 的螺纹上。
将螺栓 (1) 到螺栓 (12) 上紧到以下扭矩。 ... 4 ± 1 N·m (35 ± 9 lb in)
将螺栓 (1) 到螺栓 (12) 上紧到以下扭矩。 ... 45 ± 5 N·m (33 ± 4 lb ft)
Show/hide table
图 2 | g01188184 |
(13) 螺柱 |
(13) 将四条螺柱上紧到以下扭矩。 ... 35 ± 5 N·m (26 ± 4 lb ft)
注: 起动或运行发动机之前,使排气歧管接头处的密封剂风干 24 小时。
Caterpillar Information System:
C27 and C32 Generator Set Engines Valve Mechanism
3056E Industrial Engine Engine Oil Cooler - Install
3056E Industrial Engine Engine Oil Cooler - Remove
CIPI UNDERCARRIAGE Arrangements: 9Q-5240, 9Q-5241, 9Q-5242, 9Q-5250, 9Q-5253, 9Q-5265, 9Q-5266, 9Q-5392, 9Q-5393, 9Q-5478, 9Q-5504, 9Q-5621, 9Q-5643, 9Q-5651, 9Q-5709, 9Q-5718, 9Q-5723, 9Q-5724, 9Q-5725, 9Q-5726, 9Q-5731, 9Q-5747, 9Q-5780, 9Q-5792, 9 Recoil Spring
2003/01/01 A New Drain Valve Group is Available to Drain Condensate from the Air Plenum {1094, 1372}
CIPI UNDERCARRIAGE Arrangements: 166-7047, 177-3011, 177-3553, 177-4279, 200-2995, 200-4060, 204-0808, 212-6225, 213-8653, 215-7227, 218-2237, 231-5143, 3Q-6638, 3Q-6641, 6Z-7749, 6Z-7751, 6Z-7857, 6Z-7890, 6Z-7926, 6Z-7938, 6Z-7992, 9Q-5034, 9Q-5042 Front Idler
3126B Marine Engines CID 0102 FMI 04 Boost Pressure Sensor short to ground
C7 Petroleum Engines Basic Engine
C11, C13 and C15 On-highway Engines Injector Code - Calibrate
3126B Marine Engines CID 0102 FMI 03 Boost Pressure Sensor short to +batt
3056E Industrial Engine Water Pump - Remove and Install
C7 Petroleum Engines Air Inlet and Exhaust System
2003/03/01 New Valve Group and Coil Now Used {3139}
G3520C and G3520E Generator Set Engines Circuit Breaker
2003/02/24 A Revised Special Instruction Provides Information on Service Replacement of the Turbocharger (for Turbocharged Engines Only) {1052}
G3520C and G3520E Generator Set Engines Air/Fuel Ratio Control - Adjust
C7 and C9 On-Highway Engines Exhaust Brake Parameters
C15 On-highway Engine Valve Mechanism Cover
3056E Industrial Engine Engine Oil Filter Base - Remove and Install
C15 Petroleum Generator Set Engines Electronic Unit Injector Wiring
C7 and C9 On-Highway Engines Engine Monitoring Parameters
C11, C13 and C15 On-highway Engines Customer Specified Parameters Table
G3406 and G3412 Generator Set Engines Gas Pressure Regulator
G3406 and G3412 Generator Set Engines Gas Pressure Regulator