2002/11/01 Caterpillar

New Spacer For Marine Oil Pan Gaskets {1302}

Usage:

3196 2XR

Engine: 3176B (S/N: 9WK1-UP) 3176C (S/N: 6BW1-UP) 3196 (S/N: 2XR1-UP)

The new 193-8298 Spacer is a direct replacement for the 124-2716 Spacer. The new spacer is 0.85 mm (0.034 inch) longer than the previous spacer. The increase in length limits the amount of crush for the oil pan gasket.

Caterpillar Information System:

3056E Industrial Engine Alternator - Install

3056E Industrial Engine Alternator - Remove

3056E Industrial Engine Electric Starting Motor - Remove and Install

C7 On-highway Engine Piston and Rings

C15 Petroleum Generator Set Engines Electric Starting Motor

C7 and C9 On-Highway Engines Check Engine Lamp Circuit - Test

2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}

C7 and C9 On-Highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test

Test Sequence for Capsule Type Fuel Nozzles{0782} Test Sequence for Capsule Type Fuel Nozzles{0782}

C7 and C9 On-Highway Engines 0232-04 5 Volt Supply voltage low (21)

C7 and C9 On-Highway Engines 0232-03 5 Volt Supply voltage high (21)

3054E Industrial Engine Camshaft Bearings - Remove and Install

C7 and C9 On-Highway Engines Engine Pressure Sensor Open or Short Circuit - Test

P16, P20, P25, P28, P40 and P60 Pulverizer Maintenance Interval Schedule

3054E Industrial Engine Flywheel - Remove

3056E Industrial Engine Flywheel - Install

P16, P20, P25, P28, P40 and P60 Pulverizer Reference Material

C7 and C9 On-Highway Engines Engine Speed/Timing Sensor Circuit - Test

3054C Industrial Engine and C4.4 Marine Auxiliary Generator Set Electrical System

C7 and C9 On-Highway Engines Fast Idle Enable Circuit - Test

3500 Spark Ignited Engines Flywheel Housing

C9 Urban Transit Bus Engine Ignition Key Switch Circuit and Battery Supply Circuit - Test

C7 and C9 On-Highway Engines Injection Actuation Pressure Control Valve Circuit - Test

G3406 and G3412 Generator Set Engines Cover Group (Front Housing)