Electric Starting Motor - Remove and Install
- Turn the battery disconnect switch to the OFF position.
- Place an identification mark on all electrical wires that are connected to the starting motor. Disconnect the electrical wires from the starting motor.
Show/hide table
Illustration 1 g00543044 Typical Example - Remove nuts (1) from the studs that are in the flywheel housing.
- Remove electric starting motor (2) from the flywheel housing.
Show/hide table
Illustration 2 g00543045 Typical Example - Remove adapter ring (3) from the flywheel housing.
- Install adapter ring (3) into the flywheel housing.
Show/hide table
Illustration 4 g00543044 Typical Example - Install electric starting motor (2) on the flywheel housing.
- Install nuts (1) on the studs. Tighten nuts to a torque of
44 N·m (32 lb ft) . - Connect the electrical wires to the starting motor.
- Turn the battery disconnect switch to the ON position.
Show/hide table
Illustration 3 | g00543045 |
Typical Example |
Caterpillar Information System:
C7 On-highway Engine Piston and Rings
C15 Petroleum Generator Set Engines Electric Starting Motor
C7 and C9 On-Highway Engines Check Engine Lamp Circuit - Test
2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}
C7 and C9 On-Highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
Test Sequence for Capsule Type Fuel Nozzles{0782} Test Sequence for Capsule Type Fuel Nozzles{0782}
C7 and C9 On-Highway Engines 0232-04 5 Volt Supply voltage low (21)
C7 and C9 On-Highway Engines 0232-03 5 Volt Supply voltage high (21)
3054E Industrial Engine Camshaft Bearings - Remove and Install
3056E Industrial Engine Piston Cooling Jets - Remove and Install
3056E Industrial Engine Crankshaft Main Bearings - Remove
3406E and C15 Marine Engines Cooling System - Check - Overheating
3056E Industrial Engine Alternator - Remove
3056E Industrial Engine Alternator - Install
2002/11/01 New Spacer For Marine Oil Pan Gaskets {1302}
C7 and C9 On-Highway Engines Engine Pressure Sensor Open or Short Circuit - Test
P16, P20, P25, P28, P40 and P60 Pulverizer Maintenance Interval Schedule
3054E Industrial Engine Flywheel - Remove
3056E Industrial Engine Flywheel - Install
P16, P20, P25, P28, P40 and P60 Pulverizer Reference Material
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor Circuit - Test
3054C Industrial Engine and C4.4 Marine Auxiliary Generator Set Electrical System
C7 and C9 On-Highway Engines Fast Idle Enable Circuit - Test
3500 Spark Ignited Engines Flywheel Housing