3054E Industrial Engine Caterpillar


Flywheel - Remove

Usage:

3054E 304

拆卸步骤

表 1
所需工具    
工具     零件号     零件描述     数量    
A     -     导向螺栓 (1/2 in - 20 NF X 4 in)     2    
B     138-7575     连杆支架     1    


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。





    图 1g01148312

    典型实例

  1. 拆下两个调整螺钉,然后安装用于导向的工具 (E) 。

    注: 飞轮 (2) 的重量约为 54 kg (119 lb)。 拆下其余的调整螺钉 (1) 前,安装工具 (B) 以便支撑住飞轮 (2) 。

  1. 拆下将飞轮 (2) 固定到曲轴上的其余调整螺钉 (1) 。

  1. 从发动机上拆下飞轮 (2) 。



    图 2g01148313

  1. 检查齿圈 (4) 的状态。 如果齿圈磨损或损坏,拆下齿圈 (4) 。

    注: 标记飞轮 (2) 上齿圈 (4) 的方向以及轮齿倒角的位置,以便安装新齿圈时可以正确定位。

  1. 将飞轮 (2) 和齿圈 (4) 放在合适的支架上。 使用锤子和冲头,从飞轮 (2) 上拆下齿圈 (4) 。

Caterpillar Information System:

P16, P20, P25, P28, P40 and P60 Pulverizer Maintenance Interval Schedule
C7 and C9 On-Highway Engines Engine Pressure Sensor Open or Short Circuit - Test
2002/11/01 New Spacer For Marine Oil Pan Gaskets {1302}
3056E Industrial Engine Alternator - Install
3056E Industrial Engine Alternator - Remove
3056E Industrial Engine Electric Starting Motor - Remove and Install
C7 On-highway Engine Piston and Rings
C15 Petroleum Generator Set Engines Electric Starting Motor
C7 and C9 On-Highway Engines Check Engine Lamp Circuit - Test
2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}
C7 and C9 On-Highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
Test Sequence for Capsule Type Fuel Nozzles{0782} Test Sequence for Capsule Type Fuel Nozzles{0782}
3056E Industrial Engine Flywheel - Install
P16, P20, P25, P28, P40 and P60 Pulverizer Reference Material
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor Circuit - Test
3054C Industrial Engine and C4.4 Marine Auxiliary Generator Set Electrical System
C7 and C9 On-Highway Engines Fast Idle Enable Circuit - Test
3500 Spark Ignited Engines Flywheel Housing
C9 Urban Transit Bus Engine Ignition Key Switch Circuit and Battery Supply Circuit - Test
C7 and C9 On-Highway Engines Injection Actuation Pressure Control Valve Circuit - Test
G3406 and G3412 Generator Set Engines Cover Group (Front Housing)
C7 and C9 On-Highway Engines Injector Solenoid Circuit - Test
3500 Spark Ignited Engines Air Control Valve
3054E Industrial Engine Fan - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.