Maintenance Interval Schedule
When Required
Crusher Tooth - RebuildCrusher Tooth - Replace
Every 2 Service Hours or 4 Times Daily
Bushing (Crushing Arm) - LubricateEvery 8 Service Hours or Daily
Bearings (Cylinder Ends) - LubricateCrusher Tooth and Cutting Edge Bolts - Tighten
Walk-Around Inspection
Every 50 Service Hours or Weekly
Ring Gear - LubricateCaterpillar Information System:
C7 and C9 On-Highway Engines Engine Pressure Sensor Open or Short Circuit - Test
2002/11/01 New Spacer For Marine Oil Pan Gaskets {1302}
3056E Industrial Engine Alternator - Install
3056E Industrial Engine Alternator - Remove
3056E Industrial Engine Electric Starting Motor - Remove and Install
C7 On-highway Engine Piston and Rings
C15 Petroleum Generator Set Engines Electric Starting Motor
C7 and C9 On-Highway Engines Check Engine Lamp Circuit - Test
2002/10/28 Examine Failed Starting Motors to Understand the Reason for Failure {1453}
C7 and C9 On-Highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
Test Sequence for Capsule Type Fuel Nozzles{0782} Test Sequence for Capsule Type Fuel Nozzles{0782}
C7 and C9 On-Highway Engines 0232-04 5 Volt Supply voltage low (21)
3054E Industrial Engine Flywheel - Remove
3056E Industrial Engine Flywheel - Install
P16, P20, P25, P28, P40 and P60 Pulverizer Reference Material
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor Circuit - Test
3054C Industrial Engine and C4.4 Marine Auxiliary Generator Set Electrical System
C7 and C9 On-Highway Engines Fast Idle Enable Circuit - Test
3500 Spark Ignited Engines Flywheel Housing
C9 Urban Transit Bus Engine Ignition Key Switch Circuit and Battery Supply Circuit - Test
C7 and C9 On-Highway Engines Injection Actuation Pressure Control Valve Circuit - Test
G3406 and G3412 Generator Set Engines Cover Group (Front Housing)
C7 and C9 On-Highway Engines Injector Solenoid Circuit - Test
3500 Spark Ignited Engines Air Control Valve