Fuel System Primary Filter - Replace
Show/hide table
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. |
- Stop the engine.
- Turn the start switch to the "OFF" position. Disconnect the battery.
- Shut off the fuel tank supply valve to the engine.
- If the primary fuel filter is equipped with a drain valve, open the drain valve in order to drain any fuel from the filter case. Close the drain valve.
- Loosen the bolt (1) that is on the filter housing. Remove the filter case (3) .
Show/hide table
NOTICE |
---|
Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately. |
Show/hide table
Illustration 1 | g00485293 |
(1) Bolt (2) Element (3) Case |
- Remove the element (2) and wash the element in clean, nonflammable solvent.
- Install the element (2) and the filter case (3). Tighten the bolt (1) to a torque of 24 ± 4 N·m (18 ± 3 lb ft).
Show/hide table
NOTICE |
---|
Do not fill the fuel filters with fuel before installing them. The fuel would not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel system parts. |
Caterpillar Information System:
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Water Temperature Regulator - Test
C9 On-highway Engines Safety Messages
EMCPII+ for Gas Engines EMCP Electronic Control (Generator Set)
G3600 Engines Exhaust Bypass Valve
C9 Marine Auxiliary and Generator Set Engines Engine Crankcase Breather - Clean
3126E and 3126B Commercial and Truck Engines Product Lifting
3054E Industrial Engine Piston Cooling Jet
3606, 3608, 3612, 3616 and 3618 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Panel View Monitor Connections
3406E and C15 Marine Engines Closed Crankcase Ventilation (CCV) System
G3520B Engines Compressor Bypass
2002/08/05 Guidelines for Water Pump Visual Inspection {1361}
C280-16 Petroleum Engine Engine Speed Sensor
EMCPII+ for Gas Engines Instrument Panel
HT400 Pumper Maintenance Interval Schedule
HT400 Pumper Safety Messages
EMCPII+ for Gas Engines Normal Mode
C-10 and C-12 Truck Engines Wastegate Solenoid
C-10 and C-12 Truck Engines Fuel Lines
G3520B Engines MID 033 - CID 0041 - FMI 03 8 Volt DC Supply short to +batt
G3520B Engines MID 033 - CID 0041 - FMI 04 8 Volt DC Supply short to ground
3056E Industrial Engine Engine Oil Filter Bypass Valve
G3600 Engines Fuel Control
C-10, C-12 and C-15 On-highway Engines 0166-11 Rated Engine Power Derate
3054E Industrial Engine Exhaust Manifold