MID 033 - CID 0041 - FMI 03 8 Volt DC Supply short to +batt
Conditions Which Generate This Code:
The voltage supply from the slave Electronic Control Module (ECM) to the detonation sensors on the right side of the engine has exceeded the normal range.
System Response:
Default values are assumed for the inputs to the slave ECM from all of the detonation sensors on the right side of the engine. All of the diagnostic codes for the detonation sensors on the right side of the engine are disabled while this code is active.
The fuel is shut off. The shutdown output is activated. The code is logged.
Since the engine protection is disabled, the engine is shut down.
Test Step 1. Perform the following diagnostic procedure: +8V Sensor Voltage Supply
Results:
- OK - STOP
Caterpillar Information System:
C-10 and C-12 Truck Engines Fuel Lines
C-10 and C-12 Truck Engines Wastegate Solenoid
EMCPII+ for Gas Engines Normal Mode
HT400 Pumper Safety Messages
HT400 Pumper Maintenance Interval Schedule
EMCPII+ for Gas Engines Instrument Panel
HT400 Pumper Fuel System Primary Filter - Replace
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Water Temperature Regulator - Test
C9 On-highway Engines Safety Messages
EMCPII+ for Gas Engines EMCP Electronic Control (Generator Set)
G3600 Engines Exhaust Bypass Valve
C9 Marine Auxiliary and Generator Set Engines Engine Crankcase Breather - Clean
G3520B Engines MID 033 - CID 0041 - FMI 04 8 Volt DC Supply short to ground
3056E Industrial Engine Engine Oil Filter Bypass Valve
G3600 Engines Fuel Control
C-10, C-12 and C-15 On-highway Engines 0166-11 Rated Engine Power Derate
3054E Industrial Engine Exhaust Manifold
G3520B Engines MID 036 - CID 1720 - FMI 05 Turbo Compressor Bypass Valve Solenoid open
G3520B Engines MID 036 - CID 1720 - FMI 06 Turbo Compressor Bypass Valve Solenoid shrt to gnd
797F Off-Highway Truck Steering System Pressure Switches
Power Module Switchgear (Low Voltage and Medium Voltage) Maintenance Interval Schedule
EMCPII+ for Gas Engines Service Tools
EMCPII+ for Gas Engines Fault Identification
Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines