MID 036 - CID 1720 - FMI 05 Turbo Compressor Bypass Valve Solenoid open
Conditions Which Generate This Code:
- The output to the turbocharger compressor bypass valve solenoids from the master Electronic Control Module (ECM) is ON.
- The master ECM detects reduced current in the circuit for the turbocharger compressor bypass valve solenoids.
Note: This code can only be detected by the master ECM when the output for the turbocharger compressor bypass valve solenoids is ON. This output is normally ON during either of these conditions:
- Turbocharger surge
- Engine shutdown
Note: Engine shutdown occurs when the output for the fuel control relay is OFF and the engine RPM is above 100. The master ECM will continue to activate the output for the turbocharger compressor bypass valve solenoids until the engine RPM drops to zero.
System Response:
The shutdown indicator is activated. The code is logged.
The engine is shut down.
Test Step 1. Perform the following diagnostic procedure: Turbocharger Compressor Bypass Valve Solenoid
Results:
- OK - STOP
Caterpillar Information System:
3054E Industrial Engine Exhaust Manifold
C-10, C-12 and C-15 On-highway Engines 0166-11 Rated Engine Power Derate
G3600 Engines Fuel Control
3056E Industrial Engine Engine Oil Filter Bypass Valve
G3520B Engines MID 033 - CID 0041 - FMI 04 8 Volt DC Supply short to ground
G3520B Engines MID 033 - CID 0041 - FMI 03 8 Volt DC Supply short to +batt
C-10 and C-12 Truck Engines Fuel Lines
C-10 and C-12 Truck Engines Wastegate Solenoid
EMCPII+ for Gas Engines Normal Mode
HT400 Pumper Safety Messages
HT400 Pumper Maintenance Interval Schedule
EMCPII+ for Gas Engines Instrument Panel
G3520B Engines MID 036 - CID 1720 - FMI 06 Turbo Compressor Bypass Valve Solenoid shrt to gnd
797F Off-Highway Truck Steering System Pressure Switches
Power Module Switchgear (Low Voltage and Medium Voltage) Maintenance Interval Schedule
EMCPII+ for Gas Engines Service Tools
EMCPII+ for Gas Engines Fault Identification
Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines
2002/08/01 A New Rubber Boot Is Available To Help Protect The Actuator Shafts In The Hydrax System {1716}
3054E Industrial Engine Connecting Rod - For Use With Steel Crankshaft
Rework Instruction for Transformers that are approved by the Canadian Standards Association (CSA) for G3400C Engines with Tall Cylinder Heads{1550, 1561} Rework Instruction for Transformers that are approved by the Canadian Standards Association (CSA) for G3400C Engines with Tall Cylinder Heads{1550, 1561}
Rework Instruction for Transformers for G3400C Engines with Tall Cylinder Heads{1409, 1550, 1561} Rework Instruction for Transformers for G3400C Engines with Tall Cylinder Heads{1409, 1550, 1561}
797 and 797B Off-Highway Truck Power Train Electronic Control System Machine Speed Correction
3054E Industrial Engine Piston and Rings