Engine Oil Filter Bypass Valve
Note: There is two types of oil filter base. The high mounted Oil filter base has an oil filter bypass valve that is installed in the filter base. The other bypass valve is installed in the oil filter.
Show/hide table
Illustration 1 | g00907545 |
Oil filter bypass valve |
(1) Torque the bolt for the oil filter bypass valve to the following torque. ...
Pressure to open bypass valve ...
Caterpillar Information System:
G3520B Engines MID 033 - CID 0041 - FMI 04 8 Volt DC Supply short to ground
G3520B Engines MID 033 - CID 0041 - FMI 03 8 Volt DC Supply short to +batt
C-10 and C-12 Truck Engines Fuel Lines
C-10 and C-12 Truck Engines Wastegate Solenoid
EMCPII+ for Gas Engines Normal Mode
HT400 Pumper Safety Messages
HT400 Pumper Maintenance Interval Schedule
EMCPII+ for Gas Engines Instrument Panel
HT400 Pumper Fuel System Primary Filter - Replace
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Water Temperature Regulator - Test
C9 On-highway Engines Safety Messages
EMCPII+ for Gas Engines EMCP Electronic Control (Generator Set)
G3600 Engines Fuel Control
C-10, C-12 and C-15 On-highway Engines 0166-11 Rated Engine Power Derate
3054E Industrial Engine Exhaust Manifold
G3520B Engines MID 036 - CID 1720 - FMI 05 Turbo Compressor Bypass Valve Solenoid open
G3520B Engines MID 036 - CID 1720 - FMI 06 Turbo Compressor Bypass Valve Solenoid shrt to gnd
797F Off-Highway Truck Steering System Pressure Switches
Power Module Switchgear (Low Voltage and Medium Voltage) Maintenance Interval Schedule
EMCPII+ for Gas Engines Service Tools
EMCPII+ for Gas Engines Fault Identification
Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines Installation of the Caterpillar Ignition System (CIS) on G3612 and G3616 Engines
2002/08/01 A New Rubber Boot Is Available To Help Protect The Actuator Shafts In The Hydrax System {1716}
3054E Industrial Engine Connecting Rod - For Use With Steel Crankshaft