Product Lifting
Show/hide table
图 1 | g00103219 |
Show/hide table
注意 |
---|
千万不要折弯吊环螺栓和支架。 吊环螺栓和支架只能承受张力负荷。 要记住当支承构件和物体之间的角度小于90°时,吊环螺栓的承载能力变小。 当必须在某一角度搬移部件时,只能使用具有适当额定载荷的连杆支架。 |
使用起重机搬移重的部件。 使用一个可以调节的吊粱起吊发动机。 所有的承载构件(链条和钢丝绳)应互相平行。 链条和钢丝绳与被吊物的上部尽可能保持垂直。
有些搬移工作要求用吊装工具吊装,以确保平衡和安全。
只在搬移发动机时,才使用发动机上的吊耳。 如果吊耳失落,请参考零件手册,查找正确的吊耳和螺栓。
吊耳是为特定的发动机配置而设计和安装的。 这些吊耳是在发动机制造过程中安装的。 改动吊耳和/或发动机会使吊耳和吊具不适合改动后的情况。 如果对吊耳和/或发动机做过改动,则应确保提供合适的起吊装置。 有关发动机正确起吊的吊具资料,请与卡特彼勒代理商联系。
Caterpillar Information System:
3054E Industrial Engine Piston Cooling Jet
3606, 3608, 3612, 3616 and 3618 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Panel View Monitor Connections
3406E and C15 Marine Engines Closed Crankcase Ventilation (CCV) System
G3520B Engines Compressor Bypass
2002/08/05 Guidelines for Water Pump Visual Inspection {1361}
C280-16 Petroleum Engine Engine Speed Sensor
3406E and C15 Marine Engines Piston Ring Groove - Inspect
3054E Industrial Engine Cylinder Block
3406E and C15 Marine Engines Water Pump - Test
3406E and C15 Marine Engines Cooling System - Test
C-10, C-12 and C-15 On-highway Engines Multi-Torque - Test
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C9 Marine Auxiliary and Generator Set Engines Engine Crankcase Breather - Clean
G3600 Engines Exhaust Bypass Valve
EMCPII+ for Gas Engines EMCP Electronic Control (Generator Set)
C9 On-highway Engines Safety Messages
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Water Temperature Regulator - Test
HT400 Pumper Fuel System Primary Filter - Replace
EMCPII+ for Gas Engines Instrument Panel
HT400 Pumper Maintenance Interval Schedule
HT400 Pumper Safety Messages
EMCPII+ for Gas Engines Normal Mode
C-10 and C-12 Truck Engines Wastegate Solenoid
C-10 and C-12 Truck Engines Fuel Lines