Event Codes
使用本节对生成了事件代码但没有当前诊断代码的问题进行故障诊断和排除。 生成事件代码时,该事件处于当前状态。 生成的任何代码都会记录在电子控制模块(ECM)的永久存储器中。
事件代码提醒操作员检测到发动机工作状况异常,如机油压力低或冷却液温度高。 这些事件并不涉及电子系统的故障。 事件代码还可说明问题的性质。 可在安装了卡特彼勒电子技师(ET)软件的个人计算机上查看事件代码。
Show/hide table
图 1 | g00740986 |
典型示例 |
图 1 说明了冷却液温度传感器的输出电压。 如果传感器的输出信号在 4.2 伏到 4.8 伏之间,则会生成一个冷却液温度高于正常值的事件代码。
可对发动机进行设置,以在某些应用场合执行以下操作:
- 发动机警告
- 发动机功率降低
- 发动机停机
可使用卡特彼勒 ET 开启和关闭这些功能的显示。 开启功能显示时,电子监控模块会显示这些功能,同时会有一个事件记录在 ECM 上。 关闭功能显示时,监控模块不会显示这些功能,但 ECM 仍会记录相应事件。
系统事件代码
Show/hide table
3500B 系统事件代码     | |
---|---|
事件代码     | 说明     |
E017     | 发动机冷却液温度高警告     |
E021     | 排气温度高,功率下降     |
E035     | 没有冷却液流警告     |
E038     | 发动机冷却液温度低警告     |
E072     | 机油油位标记低     |
E073     | 机油滤清器压差高     |
E074     | 机油滤清器差压过高     |
E092     | 增压压力高于正常值     |
E093     | 增压压力低于正常值     |
E095     | 燃油滤清器堵塞警告     |
E098     | 发动机预润滑超弛     |
E100     | 发动机机油压力低警告     |
E101     | 曲轴箱压力高警告     |
E190     | 发动机超速警告     |
E265     | 用户定义停机     |
E272     | 进气堵塞警告     |
Caterpillar Information System:
3054 and 3056 Marine Generator Sets Voltage Connections
2001/09/01 New Main Bearings Provide Improved Bearing Retention in the Cylinder Block {1203}
Generator Set Start Module (AC Input) Information Plate
3512B Petroleum Engines with the ADEM 2 Electronic Control Module E097 Engine Derate Overridden
3126 Truck Engine Air Inlet Elbow
2001/09/01 Caterpillar No Longer Recommends The Use Of 195-6071 Spark Plugs Or 195-6353 Spark Plugs On G3300 Engines Or G3400 Engines {1555}
3126B and 3126E Truck Engines Electric Starting Motor
Automatic Transfer Switches CTS, CTSD Series Sensors
3512B Petroleum Engines with the ADEM 2 Electronic Control Module E085 Engine Shutdown Overridden
SCT673 Truck Mounted PumperPOD Model View Illustrations
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks E038 Low Engine Coolant Temperature Warning
3512B Petroleum Engines with the ADEM 2 Electronic Control Module E040 Low Engine Oil Pressure Shutdown
3054 and 3056 Marine Generator Sets Reference Numbers
2001/09/01 A New Service Manual Module, RENR5851 is Available for the 150-7700 Tachometer {7462}
3054 and 3056 Marine Generator Sets After Starting Engine
C6.6 Marine Generator Set Heat Exchanger - Inspect
3126 Truck Engine Air Inlet Heater
3114, 3116, and 3126 Industrial and Generator Set Engines Engine Operation - Test
3054E and 3056E Industrial Engines Fuel System Secondary Filter - Replace
3126 Truck Engine Electronic Control Wiring Group - Air Inlet Heater
2001/10/01 A Process for Product Support has been Established for the Custom Parts that are part of the 3500 Family and 3600 Family of Engine Packages {1000, 1800}
2001/10/01 Information For Determining The Correct Pulses Per Revolution For Speed Pickups On Napier 297 Turbochargers {7462}
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Control Module (Pump Pressure) - Calibrate
3054 and 3056 Marine Generator Sets Generator Lead Connections