Electronic Control Wiring Group - Air Inlet Heater
Show/hide table
Illustration 1 | g00448819 |
(1) Magnetic switch
(2) Tighten the terminal nut to the following torque. ... 6.0 ± 0.5 N·m (53 ± 4 lb in)
(3) Air inlet elbow
Note: During assembly of the air inlet heater to the inlet manifold and the air inlet elbow, clean the air inlet heater's joint faces with solvent. Apply 169-5464 Quick Cure Primer to the joint faces. Allow the primer to dry for a minimum of three to five minutes. Apply 1U-8846 Liquid Gasket to the joint face and spread the gasket maker uniformly. The heater must be assembled and tightened within ten minutes.
(4) Tighten the nuts to the following torque. ... 7.8 ± 1.0 N·m (69 ± 9 lb in)
(5) Air inlet heater
(6) Tighten the nut for the ground strap to the following torque. ... 28 ± 7 N·m (21 ± 5 lb ft)
Caterpillar Information System:
3054E and 3056E Industrial Engines Fuel System Secondary Filter - Replace
3114, 3116, and 3126 Industrial and Generator Set Engines Engine Operation - Test
3126 Truck Engine Air Inlet Heater
C6.6 Marine Generator Set Heat Exchanger - Inspect
3054 and 3056 Marine Generator Sets After Starting Engine
2001/09/01 A New Service Manual Module, RENR5851 is Available for the 150-7700 Tachometer {7462}
3054 and 3056 Marine Generator Sets Reference Numbers
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Event Codes
3054 and 3056 Marine Generator Sets Voltage Connections
2001/09/01 New Main Bearings Provide Improved Bearing Retention in the Cylinder Block {1203}
Generator Set Start Module (AC Input) Information Plate
3512B Petroleum Engines with the ADEM 2 Electronic Control Module E097 Engine Derate Overridden
2001/10/01 A Process for Product Support has been Established for the Custom Parts that are part of the 3500 Family and 3600 Family of Engine Packages {1000, 1800}
2001/10/01 Information For Determining The Correct Pulses Per Revolution For Speed Pickups On Napier 297 Turbochargers {7462}
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Control Module (Pump Pressure) - Calibrate
3054 and 3056 Marine Generator Sets Generator Lead Connections
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Control Module (Pump Rate and Engine Rate) - Calibrate
Automatic Transfer Switches CTS, CTSD Series Optional Operator Devices
3054 and 3056 Marine Generator Sets Generator Set Installation
3054 and 3056 Marine Generator Sets Generator - Dry
C15 and C18 Petroleum Generator Sets Generator - Inspect
3054 and 3056 Marine Generator Sets Generator Load - Check
3456 Generator Sets Generator Set - Test
3054 and 3056 Marine Generator Sets Insulation - Test