Air Inlet Heater
Show/hide table
Illustration 1 | g00292365 |
Section view of the air inlet heater |
(1) Air inlet heater
(2) Tighten the nuts to the following torque. ... 7.8 ± 1.0 N·m (69 ± 9 lb in)
Note: During assembly of the air inlet heater to the inlet manifold and the air inlet elbow, clean the air inlet heater's joint faces with solvent. Apply 169-5464 Quick Cure Primer to the joint faces. Allow the primer to air dry for a minimum of three to five minutes. Apply 1U-8846 Liquid Gasket to the joint face and spread the gasket maker uniformly. The heater must be assembled and tightened within ten minutes.
Caterpillar Information System:
C6.6 Marine Generator Set Heat Exchanger - Inspect
3054 and 3056 Marine Generator Sets After Starting Engine
2001/09/01 A New Service Manual Module, RENR5851 is Available for the 150-7700 Tachometer {7462}
3054 and 3056 Marine Generator Sets Reference Numbers
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Event Codes
3054 and 3056 Marine Generator Sets Voltage Connections
2001/09/01 New Main Bearings Provide Improved Bearing Retention in the Cylinder Block {1203}
Generator Set Start Module (AC Input) Information Plate
3512B Petroleum Engines with the ADEM 2 Electronic Control Module E097 Engine Derate Overridden
3126 Truck Engine Air Inlet Elbow
2001/09/01 Caterpillar No Longer Recommends The Use Of 195-6071 Spark Plugs Or 195-6353 Spark Plugs On G3300 Engines Or G3400 Engines {1555}
3126B and 3126E Truck Engines Electric Starting Motor
3114, 3116, and 3126 Industrial and Generator Set Engines Engine Operation - Test
3054E and 3056E Industrial Engines Fuel System Secondary Filter - Replace
3126 Truck Engine Electronic Control Wiring Group - Air Inlet Heater
2001/10/01 A Process for Product Support has been Established for the Custom Parts that are part of the 3500 Family and 3600 Family of Engine Packages {1000, 1800}
2001/10/01 Information For Determining The Correct Pulses Per Revolution For Speed Pickups On Napier 297 Turbochargers {7462}
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Control Module (Pump Pressure) - Calibrate
3054 and 3056 Marine Generator Sets Generator Lead Connections
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Control Module (Pump Rate and Engine Rate) - Calibrate
Automatic Transfer Switches CTS, CTSD Series Optional Operator Devices
3054 and 3056 Marine Generator Sets Generator Set Installation
3054 and 3056 Marine Generator Sets Generator - Dry
C15 and C18 Petroleum Generator Sets Generator - Inspect