Swing Cushion Valve - Assemble
Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install backup ring (10) and O-ring seal (9) on relief valve (4) .
Show/hide table
Illustration 1 | g01167462 |
- Install ball (8), plunger (7), and spring (6) in relief valve (4) .
- Repeat Steps 1 and 2 for relief valve (5) .
Show/hide table
Illustration 2 | g01167461 |
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
- Install O-ring seals (2) and (3) .
- Install relief valves (4) and (5). Tighten relief valves (4) and (5) to a torque of 69 ± 7 N·m (51 ± 5 lb ft).
- Install manifolds (1) .
End By: Install the swing cushion valve. Refer to Disassembly and Assembly, "Swing Cushion Valve - Install".
Caterpillar Information System:
325C LCR Excavator Machine Systems Swing Cushion Valve - Disassemble
325C LCR Excavator Machine Systems Swing Cushion Valve - Install
325C LCR Excavator Machine Systems Swing Cushion Valve - Remove
330D and 336D Excavators Safety Messages
325C LCR Excavator Machine Systems Refrigerant Receiver-Dryer - Remove and Install
325C Excavator Engine Supplement Unit Injector Hydraulic Pump Drive - Install
325C Excavator Engine Supplement Unit Injector Hydraulic Pump Drive - Remove
325C Excavator Engine Supplement Fuel Transfer Pump and Primary Filter (Water Separator) - Remove and Install
325C Excavator Engine Supplement Engine Electronic Control - Remove and Install
M318C and M322C Excavators Engine Supplement Alternator - Remove and Install
325C Excavator Engine Supplement Inlet Manifold - Remove and Install
M318C and M322C Excavators Engine Supplement Air Cleaner - Remove and Install
301.6C, 301.8C and 302.5C Mini Hydraulic Excavators Hydraulic System Oil Sample - Obtain
725C, 725C2, 730C, 730C2 and 730C, 730C2 EJECTOR Articulated Truck Systems Temperature Sensor (Torque Converter Oil)
325C LCR Excavator Machine Systems Upper Frame and Undercarriage Frame - Separate
325C LCR Excavator Machine Systems Upper Frame and Undercarriage Frame - Connect
C9.3 Engines for Caterpillar Built Machines Vibration Damper - Check
325C LCR Excavator Machine Systems Swing Motor and Swing Drive - Remove
M318C and M322C Excavators Engine Supplement Engine - Remove
M318C and M322C Excavators Engine Supplement Engine - Install
325C LCR Excavator Machine Systems Swing Motor and Swing Drive - Install
325C LCR Excavator Machine Systems Swing Motor - Remove
325C LCR Excavator Machine Systems Swing Motor - Install
345C MHPU Mobile Hydraulic Power Unit Specifications - Ultrahigh Demolition Configuration