Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Show/hide table
|
|
|
Illustration 1 | g01167384 |
- Disconnect hose (1) and harness assembly (5) .
- Remove bolts (3), elbow (2), and spacer (4) .
Show/hide table
|
|
|
Illustration 2 | g01167385 |
- Disconnect harness assembly (6), cable assembly (7), and relay (8) .
Show/hide table
|
|
|
Illustration 3 | g01190669 |
- Remove eight bolts (9) in order to remove inlet manifold (10) .
Installation Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
1U-8846     |
Gasket Sealant     |
1     |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Show/hide table
|
|
|
Illustration 4 | g01190669 |
- Apply Tooling (A) to the mating surface of inlet manifold (10) and the cylinder head.
- Position inlet manifold (10) and install bolts (9) .
Show/hide table
|
|
|
Illustration 5 | g01167385 |
- Connect relay (8), cable assembly (7), and harness assembly (6) .
Show/hide table
|
|
|
Illustration 6 | g01167384 |
- Apply Tooling (A) to the mating surfaces of the inlet manifold, spacer (4), and elbow (3) .
- Install spacer (4), elbow (2), and bolts (3) .
- Connect harness assembly (5) and hose (1) .