Visual Inspection
Show/hide table
NOTICE |
---|
Accumulated grease and oil on a work tool is a fire hazard. Remove debris with steam cleaning or high pressure water at any time a significant quantity of oil is spilled on the work tool. |
Note: If major repairs to the Work Tool are required, consult your Verachtert dealer.
- For the maximum service life of the Work Tool, make a thorough walk-around inspection before you mount the machine and before you start the machine.
- Inspect the Work Tool for the following conditions: loose bolts, worn teeth, broken parts and worn parts. Inspect the Work Tool for missing parts. Check the overall condition of the Work Tool.
- Inspect the jaws of the Work Tool. Remove all scrap from the jaws.
- Inspect the welds, the pins, and the bores for damage. If the components are damaged, consult your Verachtert dealer.
- Perform all repairs before you put the Work Tool into service.
- Check safety signs and labels.
- Lubricate pins.
Caterpillar Information System:
VPG-25, VPG-35, VPG-45 and VPG-55 Work Tools Grapple
312C Excavator Engine Air Filter Secondary Element - Replace
311C U Excavator Hydraulic System Main Hydraulic System
Product Identification Numbers (PIN) Location Guide Track-Type Tractor
5110B Excavator Machine Systems Swivel - Assemble
Product Identification Numbers (PIN) Location Guide Excavator (Track)
BA22, BA25 and BA30 Angling Brooms Brooms - BA25
BA22, BA25 and BA30 Angling Brooms Brooms - BA22
311C U Excavator Hydraulic System General Information
311C Excavator Machine System Specifications Stick - 2250 mm (7 ft 5 inch)
5110B Excavator Machine Systems Track Tension Cylinder - Install
365B and 365B Series II Excavators Hydraulic System Fan Motor Speed (Hydraulic and Radiator Cooling) - Test and Adjust
365B and 365B Series II Excavators Hydraulic System Fan Motor (Hydraulic and Radiator Cooling) - Test - Measurement of Case Drain Oil
312C and 315C Excavators Tool Control System System 3: Relief Valve (Line) - Test and Adjust
315C Excavator Fuel Inlet Screen - Clean
5110B Excavator Machine Systems Control Valve (Implement and Travel) - Disassemble
315C Excavator Hydraulic System General Information
315C Excavator Hydraulic System Swivel
Instructions for the Use of the M300 Technician Software With a Laptop Computer{7620} Instructions for the Use of the M300 Technician Software With a Laptop Computer{7620}
VPG-25, VPG-35, VPG-45 and VPG-55 Work Tools Grapple - Disassemble
5110B Excavator Machine Systems Bucket - Remove and Install
VPG-25, VPG-35, VPG-45 and VPG-55 Work Tools Grapple - Disassemble
VPG-25, VPG-35, VPG-45 and VPG-55 Work Tools Grapple - Disassemble
Installation of the Blank Hooks{6530, 6700} Installation of the Blank Hooks{6530, 6700}