Water Temperature Regulators - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 2 |
B | 1P-0510 | Driver Group | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tool (B) to install seals (8), if necessary. Ensure that the lip of the seal is toward the inside of the housing.
Show/hide table
NOTICE If the water temperature regulator is installed incorrectly, it will cause the engine to overheat.
Show/hide tableIllustration 3 g00602198 - Install four water temperature regulators (5) with the spring upward. Install gasket (6).
Show/hide table
Illustration 4 g00602197 - Use Tool (A) and a suitable lifting device to position water temperature regulator housing (4) on the engine. Install bolts (3).
Show/hide table
Illustration 5 g00602196 - Connect two tubes (2) to the water temperature regulator housing.
Show/hide table
Illustration 6 g00624685 - Install a new seal for the elbow in hose (1). Lubricate the bore of the seal with glycerin. Connect hose (1) to the water temperature regulator housing.
- Fill the cooling with coolant to the correct level. See the Operation and Maintenance Manual for the correct coolant to use.
Show/hide table
Illustration 1 | g00602271 |
Show/hide table
Illustration 2 | g00602328 |
Caterpillar Information System:
3512B Marine Auxiliary Engines Water Temperature Regulators - Remove
3126B Truck Engine Fuel System
3512B Marine Auxiliary Engines Exhaust Manifold - Remove and Install
3512B Marine Auxiliary Engines Exhaust Elbow - Remove and Install
C-9 Engines for Caterpillar Built Machines Piston and Rings
3612 and 3616 Engines Fuel Pressure Control Valve - Disassemble
C-15, C-16 and C-18 Truck Engines Housing (Front) - Remove
On-Highway Engines Electronic PTO Installation and Application Guide Component Installation
3512B Marine Auxiliary Engines Air Inlet Manifold - Remove and Install
3512B Marine Auxiliary Engines Aftercooler - Remove and Install
Generator Set Load Sharing Module Installation Requirements
Generator Set Load Sharing Module Phasing - Adjust
30SI Series and 34SI Series Alternator Alternator
Caterpillar Monitoring System for Electronic Modular Control Panel General Information
C-15, C-16 and C-18 Truck Engines Housing (Front) - Install
3116 On Highway Engines Turbocharger - Remove
3116 On Highway Engines Turbocharger - Install
3512B Marine Auxiliary Engine Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting
3003, 3013, 3014 and 3024 Industrial Engines Engine Description
3116 On Highway Engines Exhaust Manifold - Remove and Install
3512B Marine Auxiliary Engines Crankshaft Main Bearings - Install
3512B Marine Auxiliary Engines Camshaft - Remove
3512B Marine Auxiliary Engines Camshaft - Install
3512B Marine Auxiliary Engines Crankshaft - Remove