Fuel Pressure Control Valve - Disassemble
拆解步骤
开始:
- 卸下燃油压力控制阀。 请参阅拆解和装配, "燃油压力控制阀 - 拆卸"。
- 松开锁紧螺母，然后将固定螺钉 (6) 从板 (5) 上卸下。
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
 | |
| 图 1 | g00624682 |
Show/hide table
 |
弹簧加压的零件和/或盖板可能导致人身伤害。 拆卸盖板时弹簧力将被释放。 松动螺栓时做好准备把持住弹簧加载的盖板。 |
- 将螺栓和板 (5) 从主体 (1) 上卸下。
- 将护圈 (4) 、弹簧 (3) 和阀 (2) 从主体 (1) 上卸下。
- 将 O 形密封圈从护圈 (4) 上卸下。
Caterpillar Information System:
C-15, C-16 and C-18 Truck Engines Housing (Front) - Remove
On-Highway Engines Electronic PTO Installation and Application Guide Component Installation
3512B Marine Auxiliary Engines Air Inlet Manifold - Remove and Install
3512B Marine Auxiliary Engines Aftercooler - Remove and Install
Generator Set Load Sharing Module Installation Requirements
Generator Set Load Sharing Module Phasing - Adjust
Generator Set Load Sharing Module Load Gain - Adjust
Generator Set Load Sharing Module Droop - Adjust
3512B Marine Auxiliary Engines Air Starting Motor - Install
Generator Set Load Sharing Module Wiring Diagrams
Generator Set Load Sharing Module Engine Does Not Properly Share Load - Troubleshoot
Generator Set Load Sharing Module Load Signal Voltage Is High - Troubleshoot
C-9 Engines for Caterpillar Built Machines Piston and Rings
3512B Marine Auxiliary Engines Exhaust Elbow - Remove and Install
3512B Marine Auxiliary Engines Exhaust Manifold - Remove and Install
3126B Truck Engine Fuel System
3512B Marine Auxiliary Engines Water Temperature Regulators - Remove
3512B Marine Auxiliary Engines Water Temperature Regulators - Install
30SI Series and 34SI Series Alternator Alternator
Caterpillar Monitoring System for Electronic Modular Control Panel General Information
C-15, C-16 and C-18 Truck Engines Housing (Front) - Install
3116 On Highway Engines Turbocharger - Remove
3116 On Highway Engines Turbocharger - Install
3512B Marine Auxiliary Engine Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting