Exhaust Elbow - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 2 |
Start By:
- Remove the turbochargers.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove nuts, bolts, and washers (1) in order to remove exhaust piping (2) from exhaust elbow (3).
- Remove the gasket from the joint between exhaust piping (2) and exhaust elbow (3). Discard the gasket.
- Install Tool (A) into the top of exhaust elbow (3).
- Attach a suitable lifting device to Tool (A). The exhaust elbow weighs approximately
26 kg (57 lb) . - Remove four bolts and washers (4).
Show/hide table
Illustration 2 g00635991 - Remove four bolts and washers (5). Lift exhaust elbow (3) from the engine.
Show/hide table
Illustration 1 | g00635990 |
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 2 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install Tool (A) into the top of exhaust elbow (3).
- Attach a suitable lifting device to Tool (A). The exhaust elbow weighs approximately
26 kg (57 lb) .Show/hide tableIllustration 3 g00635991 - Lift exhaust elbow (3) into position on the engine. Install four bolts and washers (5).
Show/hide table
Illustration 4 g00635990 - Install four bolts and washers (4).
- Install a new gasket for the joint between exhaust piping (2) and exhaust elbow (3).
- Position exhaust piping (2) onto exhaust elbow (3). Install nuts, bolts, and washers (1) in order to attach exhaust piping (2) to exhaust elbow (3).
End By:
- Install the turbochargers.
Caterpillar Information System:
C-9 Engines for Caterpillar Built Machines Piston and Rings
3612 and 3616 Engines Fuel Pressure Control Valve - Disassemble
C-15, C-16 and C-18 Truck Engines Housing (Front) - Remove
On-Highway Engines Electronic PTO Installation and Application Guide Component Installation
3512B Marine Auxiliary Engines Air Inlet Manifold - Remove and Install
3512B Marine Auxiliary Engines Aftercooler - Remove and Install
Generator Set Load Sharing Module Installation Requirements
Generator Set Load Sharing Module Phasing - Adjust
Generator Set Load Sharing Module Load Gain - Adjust
Generator Set Load Sharing Module Droop - Adjust
3512B Marine Auxiliary Engines Air Starting Motor - Install
Generator Set Load Sharing Module Wiring Diagrams
3512B Marine Auxiliary Engines Exhaust Manifold - Remove and Install
3126B Truck Engine Fuel System
3512B Marine Auxiliary Engines Water Temperature Regulators - Remove
3512B Marine Auxiliary Engines Water Temperature Regulators - Install
30SI Series and 34SI Series Alternator Alternator
Caterpillar Monitoring System for Electronic Modular Control Panel General Information
C-15, C-16 and C-18 Truck Engines Housing (Front) - Install
3116 On Highway Engines Turbocharger - Remove
3116 On Highway Engines Turbocharger - Install
3512B Marine Auxiliary Engine Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting
3003, 3013, 3014 and 3024 Industrial Engines Engine Description
3116 On Highway Engines Exhaust Manifold - Remove and Install