Water Temperature Regulators - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 2 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Drain the cooling system until the level of the coolant is below the exhaust manifolds.
Show/hide table
Illustration 1 g00624685 - Disconnect hose (1) from the water temperature regulator housing. Unless the hose will be replaced, leave the hose attached to the aftercooler.
Show/hide table
Illustration 2 g00602196 - Disconnect two tubes (2) from the water temperature regulator housing.
Show/hide table
Illustration 3 g00602197 Typical example - Attach Tool (A) and a suitable lifting device. Remove bolts (3). Remove water temperature regulator housing (4).
Show/hide table
Illustration 4 g00602198 - Remove four water temperature regulators (5). Remove gasket (6).
Visually inspect ferrule (7) and the seals for water temperature regulators (5). Obtain new parts for assembly, if necessary.
Caterpillar Information System:
3126B Truck Engine Fuel System
3512B Marine Auxiliary Engines Exhaust Manifold - Remove and Install
3512B Marine Auxiliary Engines Exhaust Elbow - Remove and Install
C-9 Engines for Caterpillar Built Machines Piston and Rings
3612 and 3616 Engines Fuel Pressure Control Valve - Disassemble
C-15, C-16 and C-18 Truck Engines Housing (Front) - Remove
On-Highway Engines Electronic PTO Installation and Application Guide Component Installation
3512B Marine Auxiliary Engines Air Inlet Manifold - Remove and Install
3512B Marine Auxiliary Engines Aftercooler - Remove and Install
Generator Set Load Sharing Module Installation Requirements
Generator Set Load Sharing Module Phasing - Adjust
Generator Set Load Sharing Module Load Gain - Adjust
3512B Marine Auxiliary Engines Water Temperature Regulators - Install
30SI Series and 34SI Series Alternator Alternator
Caterpillar Monitoring System for Electronic Modular Control Panel General Information
C-15, C-16 and C-18 Truck Engines Housing (Front) - Install
3116 On Highway Engines Turbocharger - Remove
3116 On Highway Engines Turbocharger - Install
3512B Marine Auxiliary Engine Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting
3003, 3013, 3014 and 3024 Industrial Engines Engine Description
3116 On Highway Engines Exhaust Manifold - Remove and Install
3512B Marine Auxiliary Engines Crankshaft Main Bearings - Install
3512B Marine Auxiliary Engines Camshaft - Remove
3512B Marine Auxiliary Engines Camshaft - Install