Air Inlet Manifold - Remove and Install
Start By:
- Remove the aftercooler.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) and the washers. Pry flanges (2) on the elbows away from the air inlet manifold. Each cylinder has one elbow for inlet air.
- Remove bolts (3).
Show/hide table
Illustration 2 g00598890 - Attach suitable straps and a lifting device to air inlet manifold (4). The air inlet manifold weighs approximately
50 kg (110 lb) . Remove air inlet manifold (4).
Show/hide table
Illustration 1 | g00598884 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Attach suitable straps and a lifting device to air inlet manifold (4). The air inlet manifold weighs approximately
50 kg (110 lb) . Lift the manifold into position on the engine.Show/hide tableIllustration 4 g00598884 - Install bolts (3).
- Use washers and bolts (1) to install flanges (2) for the elbows. Each cylinder has one elbow for inlet air.
Show/hide table
Illustration 3 | g00598890 |
End By:
- Install the aftercooler.
Caterpillar Information System:
3512B Marine Auxiliary Engines Aftercooler - Remove and Install
Generator Set Load Sharing Module Installation Requirements
Generator Set Load Sharing Module Phasing - Adjust
Generator Set Load Sharing Module Load Gain - Adjust
Generator Set Load Sharing Module Droop - Adjust
3512B Marine Auxiliary Engines Air Starting Motor - Install
Generator Set Load Sharing Module Wiring Diagrams
Generator Set Load Sharing Module Engine Does Not Properly Share Load - Troubleshoot
Generator Set Load Sharing Module Load Signal Voltage Is High - Troubleshoot
Generator Set Load Sharing Module Load Signal Voltage Is Low - Troubleshoot
Generator Set Load Sharing Module Erratic Operation of Load Sharing Module - Troubleshoot
Generator Set Load Sharing Module Undesired Speed Decrease with Load Increase - Troubleshoot
On-Highway Engines Electronic PTO Installation and Application Guide Component Installation
C-15, C-16 and C-18 Truck Engines Housing (Front) - Remove
3612 and 3616 Engines Fuel Pressure Control Valve - Disassemble
C-9 Engines for Caterpillar Built Machines Piston and Rings
3512B Marine Auxiliary Engines Exhaust Elbow - Remove and Install
3512B Marine Auxiliary Engines Exhaust Manifold - Remove and Install
3126B Truck Engine Fuel System
3512B Marine Auxiliary Engines Water Temperature Regulators - Remove
3512B Marine Auxiliary Engines Water Temperature Regulators - Install
30SI Series and 34SI Series Alternator Alternator
Caterpillar Monitoring System for Electronic Modular Control Panel General Information
C-15, C-16 and C-18 Truck Engines Housing (Front) - Install