Blade Linkage - Lubricate
Service a new machine after Every 10 Service Hours only within the initial 100 service hours.
After the initial 100 service hours of operation, service the blade linkage after Every 50 Service Hours.
Note: If the machine is operated under severe conditions that might cause abrasive material to enter the cylinder bearings, service the blade linkage after Every 10 Service Hours.
Wipe all fittings before you apply lubricant.
- Apply lubricant through fitting (1). This fitting is located on the rod end of each blade cylinder.
- Apply lubricant through fitting (2). This fitting is located on each of the bars that support the blade.
- Apply lubricant through fitting (3). This fitting is located on the head end of each blade cylinder.
Show/hide table
| |
| Illustration 1 | g00612654 |
Caterpillar Information System:
BP15 Pickup Broom Gutter Brush Adjustment
3126B Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
3126B Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
307B Excavator Machine Systems Blade Cylinder - Disassemble
307B Excavator Machine System Specifications Relief Valve (Pilot)
3524B Engine for Caterpillar Built Machines Crankshaft Main Bearings - Install
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Install
C-9 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
345B, 345B Series II and W345B Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Assemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Counterweight Cylinder - Assemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Counterweight Cylinder - Disassemble
307B Excavator Machine System Specifications Boom - 3550 mm (139.8 inch)
BP15 Pickup Broom Wire Bristle (Gutter Brush) - Inspect/Replace
3064 and 3066 Engines for Caterpillar Built Machines Camshaft Bearings - Install
307B Excavator Indicators and Gauges - Test
3126B and 3126E On-highway Engines Flywheel Housing - Remove and Install
307B Excavator Overload Warning Device
307B Excavator Seat Heater - If Equipped
3524B Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove
330B Excavator Material Handler Machine Systems Boom Cylinder - Remove
C-9 Engines for Caterpillar Built Machines Engine Oil Pan
3524B Engine for Caterpillar Built Machines Pistons and Connecting Rods - Install
C15 and C18 Petroleum Generator Sets Engine Operation with Intermittent Diagnostic Codes
3114, 3116 and 3126 MUI Engine Governors Installation of Governor on 1U7326 Governor Calibration Bench