Solenoid Valve (Counterweight Circuit) - Assemble
Assembly Procedure
- Install stop (5), spring (6), washer (7), and O-ring seal (8) .
Show/hide table
Illustration 1 | g00612366 |
- Install solenoid assembly (10). Install bolts (9). Tighten bolts (9) to a torque of 3.9 ± 1 N·m (35 ± 9 lb in).
- Install O-ring seal (11) on plug (12) .
- Install plug (12). Tighten plug (12) to a torque of 49 ± 4.9 N·m (36 ± 3.6 lb ft).
- Install spring (4) .
- Install O-ring seal (3) on plug (2) .
- Install plug (2). Tighten plug (2) to a torque of 49 ± 4.9 N·m (36 ± 3.6 lb ft).
- Install plug (1). Tighten plug (1) to a torque of 5.9 ± 1 N·m (52 ± 9 lb in).
End By: Install the solenoid valve for the counterweight circuit. Refer to Disassembly and Assembly, "Solenoid Valve (Counterweight Circuit) - Install" in this manual.
Caterpillar Information System:
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Counterweight Cylinder - Assemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Counterweight Cylinder - Disassemble
307B Excavator Machine System Specifications Boom - 3550 mm (139.8 inch)
307B Excavator Machine Systems Blade Cylinder - Install
345B, 345B Series II and W345B Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Disassemble
C-9 Engines for Caterpillar Built Machines Exhaust Manifold
3524B Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3126B Engines for Caterpillar Built Machines Housing (Front) - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Remove
307B Excavator Machine Systems Blade Cylinder - Remove
W330B Material Handler Swing Gear - Lubricate
W330B Material Handler Swing Drive Oil Level - Check
C-9 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Install
3524B Engine for Caterpillar Built Machines Crankshaft Main Bearings - Install
307B Excavator Machine System Specifications Relief Valve (Pilot)
307B Excavator Machine Systems Blade Cylinder - Disassemble
3126B Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3126B Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
BP15 Pickup Broom Gutter Brush Adjustment
307B Excavator Blade Linkage - Lubricate
BP15 Pickup Broom Wire Bristle (Gutter Brush) - Inspect/Replace
3064 and 3066 Engines for Caterpillar Built Machines Camshaft Bearings - Install
307B Excavator Indicators and Gauges - Test