Gutter Brush Adjustment
Gutter Brush Contact Area
Show/hide table
Illustration 1 | g00553545 |
Gutter brush contact area. Left brush (A) and right brush (B) |
Only a portion of the gutter brush contacts the sweeping surface when the gutter brush is adjusted properly. Refer to Illustration 1 for the contact areas when the gutter brush is mounted on the left side of the pickup broom or on the right side of the pickup broom.
- Lower the gutter brush onto the sweeping surface.
Show/hide table
Illustration 2 | g00622942 |
- Loosen two bolts (1) that hold motor mounting plate (4) to bracket (2) .
- Rotate the motor mounting plate and adjust tension chain (3) in order to achieve the desired contact area.
- Tighten the two bolts.
Gutter Brush Swing
- Loosen nut (1) .
Show/hide table
Illustration 3 | g00622947 |
- Adjust bolt (2) inward or adjust bolt (2) outward until the gutter brush swings approximately 13 mm (0.5 inch).
- Tighten the nut.
Caterpillar Information System:
3126B Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
3126B Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
307B Excavator Machine Systems Blade Cylinder - Disassemble
307B Excavator Machine System Specifications Relief Valve (Pilot)
3524B Engine for Caterpillar Built Machines Crankshaft Main Bearings - Install
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Install
C-9 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
345B, 345B Series II and W345B Series II Excavators Machine Systems Solenoid Valve (Counterweight Circuit) - Assemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Counterweight Cylinder - Assemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Counterweight Cylinder - Disassemble
307B Excavator Machine System Specifications Boom - 3550 mm (139.8 inch)
307B Excavator Machine Systems Blade Cylinder - Install
307B Excavator Blade Linkage - Lubricate
BP15 Pickup Broom Wire Bristle (Gutter Brush) - Inspect/Replace
3064 and 3066 Engines for Caterpillar Built Machines Camshaft Bearings - Install
307B Excavator Indicators and Gauges - Test
3126B and 3126E On-highway Engines Flywheel Housing - Remove and Install
307B Excavator Overload Warning Device
307B Excavator Seat Heater - If Equipped
3524B Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove
330B Excavator Material Handler Machine Systems Boom Cylinder - Remove
C-9 Engines for Caterpillar Built Machines Engine Oil Pan
3524B Engine for Caterpillar Built Machines Pistons and Connecting Rods - Install
C15 and C18 Petroleum Generator Sets Engine Operation with Intermittent Diagnostic Codes