Engine Oil Cooler - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the oil from the engine oil filter base into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
- Remove the bolts that hold oil cooler bonnet (4) of the engine oil cooler to the water pump.
Show/hide table
 | |
| Illustration 1 | g00593892 |
- Remove bolts (3) that hold the engine oil cooler to the engine oil filter base.
- Remove bolts (1) that hold the engine oil cooler to the cylinder block. Remove engine oil cooler (2) .
Caterpillar Information System:
G3500 Engines Water Temperature Regulators - Remove
3512B and 3516B Engines Air Inlet and Exhaust Lines
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Rear Seal Carrier - If Equipped
G3500 Engines Thermostatic Valve - Assemble
G3500 Engines Thermostatic Valve - Disassemble
3500B and 3500B High Displacement Generator Set Engines System Configuration Parameters
G3500 Engines Thermostatic Valve - Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Sensors
G3500 Engines Thermostatic Valve - Remove
Electronic Modular Control Panel II (EMCP II) For PEEC Engines General Information
3512B and 3516B Engines Turbocharger
Electronic Modular Control Panel II (EMCP II) For PEEC Engines EMCP Electronic Control (Generator Set)
3406E Truck Engines Piston and Rings
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Instrument Panel
G3500 Engines Water Temperature Regulators - Install
G3500 Engines Turbocharger - Remove
3034 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Pump - Remove - 3003 Engines
G3606 and G3608 Engines Exhaust Bypass - Install
G3606 and G3608 Engines Gas Admission Valve - Install
G3606 and G3608 Engines Prechamber Ignition Body - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Cylinder Block Cover Group
3500B and 3500B High Displacement Generator Set Engines Customer Parameters Worksheet
G3612 and G3616 Engines Air/Fuel Pressure Sensor Module - Remove and Install