Cylinder Block Cover Group
Show/hide table
 | |
| 图 1 | g00448151 |
典型实例 发动机左视图 | |
Show/hide table
 | |
| 图 2 | g00471794 |
A-A 视图 | |
(1) 缸体
(2) 垫圈
密封垫 (2) 的一个表面有一个凸缘。 安装密封垫时使这个凸缘朝向侧盖 (8) 。
(3) 两个螺栓的长度 ... 40.0 mm (1.58 in)
(4) 标有位置 (Y) 的 11 个螺栓的长度。 ... 20.0 mm (0.79 in)
3 个侧盖的其余 10 个螺栓的长度。 ... 30.0 mm (1.18 in)
(5) 罩盖
利用溶剂清洗端盖表面。 将 1U-8846 液体密封垫 涂敷在盖上。 使该密封胶沿端盖表面和螺栓孔四周均匀分布。 端盖必须在 10 分钟内安装和上紧。
(6) 套筒 (7) 从缸体 (1) 表面伸出。 距离 ... 5.0 ± 0.5 mm (0.20 ± 0.02 in)
(7) 标有位置 (X) 的 6 个套筒。
(8) 侧盖
Show/hide table
 | |
| 图 3 | g00448150 |
侧盖的典型示例 | |
按数字顺序拧紧螺栓（1 至 8）。
将螺栓再次拧紧至以下扭矩。 ... 28 ± 7 N·m (21 ± 5 lb ft)
Caterpillar Information System:
G3606 and G3608 Engines Prechamber Ignition Body - Install
G3606 and G3608 Engines Gas Admission Valve - Install
G3606 and G3608 Engines Exhaust Bypass - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Pump - Remove - 3003 Engines
3034 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
G3500 Engines Turbocharger - Remove
G3500 Engines Water Temperature Regulators - Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Instrument Panel
3406E Truck Engines Piston and Rings
3406E and 3456 Generator Set Engines Engine Oil Cooler - Remove
G3500 Engines Water Temperature Regulators - Remove
3512B and 3516B Engines Air Inlet and Exhaust Lines
3500B and 3500B High Displacement Generator Set Engines Customer Parameters Worksheet
G3612 and G3616 Engines Air/Fuel Pressure Sensor Module - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Crankshaft
G3500 Engines Turbocharger - Install
G3500 Engines Turbocharger - Disassemble
3406E and 3456 Generator Set Engines Engine Oil Cooler - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines Modes Of Operation
G3606 and G3608 Engines Crankcase Cover - Remove and Install
G3606 and G3608 Engines Accessory Module Frame (Front) - Remove
3034 Engine for Caterpillar Built Machines Engine Oil Pump - Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Normal Mode
3406E and 3456 Generator Set Engines Engine Oil Cooler - Disassemble