Thermostatic Valve - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install plate (11) and bolt (9), if necessary.
- Install seal (8) and retaining screw (10), if necessary.
Show/hide table
Illustration 2 g00593619 - Assemble lower housing (5), thermostat (4), O-ring seal (3), upper housing (2), and bolt (7).
- Install plug (6) and tubes (1).
Show/hide table
Illustration 1 | g01252074 |
End By:
- Install the thermostatic valve. Refer to Disassembly and Assembly, "Thermostatic Valve - Install".
Caterpillar Information System:
G3500 Engines Thermostatic Valve - Disassemble
3500B and 3500B High Displacement Generator Set Engines System Configuration Parameters
G3500 Engines Thermostatic Valve - Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Sensors
G3500 Engines Thermostatic Valve - Remove
Electronic Modular Control Panel II (EMCP II) For PEEC Engines General Information
3512B and 3516B Engines Turbocharger
Electronic Modular Control Panel II (EMCP II) For PEEC Engines EMCP Electronic Control (Generator Set)
3406E and 3456 Generator Set Engines Water Temperature Regulator - Remove and Install
3406E and 3456 Generator Set Engines Coolant Temperature Sensor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Component Location
3406E Marine Engine Circuit Breakers
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Rear Seal Carrier - If Equipped
3512B and 3516B Engines Air Inlet and Exhaust Lines
G3500 Engines Water Temperature Regulators - Remove
3406E and 3456 Generator Set Engines Engine Oil Cooler - Remove
3406E Truck Engines Piston and Rings
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Instrument Panel
G3500 Engines Water Temperature Regulators - Install
G3500 Engines Turbocharger - Remove
3034 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Pump - Remove - 3003 Engines
G3606 and G3608 Engines Exhaust Bypass - Install
G3606 and G3608 Engines Gas Admission Valve - Install