Installation Procedure
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Position the correct number of shims (3) on the mounting face of the cylinder block. Refer to Specifications, "Fuel Injection Pump".
Illustration 1 | g00825132 |
- Position fuel injection pump (1) close to the mounting face of the cylinder block, and connect link (6) and fuel rack control (5) with clip (7) .
Illustration 2 | g00825137 |
- Put fuel injection pump (1) in position on the mounting face of the cylinder block.
- Install bolts (4) and nuts (2) that fasten the fuel injection pump to the cylinder block. Tighten bolts (4) and nuts (2) to the following torque.
3003 Engine ... 6 N·m (4 lb ft)
3013, 3014, and 3024 Engines ... 15 N·m (11 lb ft)
3024C Engine ... 15 N·m (11 lb ft)
End By:
- Install the fuel shutoff solenoid. Refer to Disassembly and Assembly, "Fuel Shutoff Solenoid - Remove and Install".
- Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".