Engine Oil Pump - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 2 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Place clean engine oil on the O-ring seals. Attach Tooling (A) and a suitable lifting device to engine oil pump (9). The weight of engine oil pump (9) is approximately
39 kg (86 lb) . - Ensure that the splines on the shaft of engine oil pump (9) are correctly engaged with the splines of the engine oil pump drive gear. Install bolts (10) and (11).
- Connect clip (12).
Show/hide table
Illustration 2 g01253313 - Place clean engine oil on the O-ring seals and install tube (5) in elbow (6). Install bolts (7).
- Place clean engine oil on the O-ring seals and install tube (8) and the flange on the engine oil cooler bonnet.
Show/hide table
Illustration 3 g01253311 - Install the gaskets and adapter (1) with bolts (2), (3), and (4).
- Fill the cooling system to the correct level with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 1 | g00591832 |
Caterpillar Information System:
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0261 - FMI 13 Engine Timing calibration required
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0827 - FMI 08 Left Exhaust Temperature signal abnormal
3406E and 3456 Generator Set Engines Front Cover - Install
G3500 Engines Engine Oil Pump - Remove
3500B Engines Engine Oil Cooler - Assemble
3500B Engines Engine Oil Cooler - Disassemble
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0545 - FMI 05 Ether Start Relay open/short to +batt
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0545 - FMI 06 Ether Start Relay short to ground
G3500 Engines Engine Oil Cooler - Install
3406E and 3456 Generator Set Engines Front Cover - Remove
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0248 - FMI 09 Cat Data Link not communicating
3304B and 3306B Engines for Caterpillar Built Machines Cylinder Head - Install
3408E and 3412E Engines for Caterpillar Built Machines Compression - Test
G3500 Engines Engine Oil Pump - Disassemble
3176C and 3196 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
3408E and 3412E Engines for Caterpillar Built Machines Cooling System - Inspect
G3500 Engines Engine Oil Pump - Assemble
3176C and 3196 Engines for Caterpillar Built Machines Cooling System - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Pump - Install
C15 Petroleum Generator Set Engines Water Temperature Regulator - Test
3176C and 3196 Engines for Caterpillar Built Machines Water Pump - Test
G3500 Engines Auxiliary Water Pump - Remove
C15 Petroleum Generator Set Engines Cooling System - Check - Overheating
XQ300, XQ400 Rental Generator Sets Monitoring System