Usage:
CONFIDENTIAL TIBU4226-00
TECHNICAL INFORMATION BULLETIN |
April 28, 2004 |
MINI HYDRAULIC EXCAVATORS |
301.5 (3YW1-UP) 301.6 (BDH1-UP) 301.8 (BFA1-UP) 302.5 (4AZ1-UP) 303 (DMA1-UP) 303.5 (DCH1-UP, AFW1-UP) 304 (NAD1-UP) 304.5 (WAK1-UP, ANR1-UP) 305 (DSA1-UP) |
Component Code(s) 6129 |
SUBJECT: Quick Coupler to Bucket Interference
PROBLEM:
There are reports of quick couplers with front and/or rear jaws that are too wide to fit between the pin bosses on the certain buckets.
SOLUTION:
Improvements are being made to the manufacturing process that will eliminate any interference complications. Do not attempt to grind or make repairs to the defective couplers. Do not attempt to grind or make repairs to the buckets, in any circumstances. Dealers should address issues to DSN. The affected machines and part numbers are listed in table 1. See illustration 1 for the details about the maximum width across the coupler jaws.
Table 1
Affected Machines and Part Numbers |
|
Model |
Part number |
301.5 301.6 301.8 |
|
302.5 |
|
303.5 303CR |
|
304.5 304CR 305CR |
Illustration 1. Measurement Locations
Note:
Dimension ?X? is the dimension across the front and rear jaw. It is associated with both the "lead-in" to the bucket boss and the area that interfaces with the bucket boss. Table 2 below, shows details about the maximum width across the coupler jaws for each coupler size.
Table 2. Dimensions
Coupler Part Number |
Coupler Size |
Maximum Dimension (X) |
301.5 301.6 301.8 |
102 mm (4.016 inch) |
|
302.5 |
133 mm (5.240 inch) |
|
303.5 303CR |
133 mm (5.240 inch) |
|
304 304.5 305CR |
153 mm (6.024 inch) |
COPYRIGHT 2004 CATERPILLAR
ALL RIGHTS RESERVED