OPERATION OF BUCKET MAY EXPERIENCE A CYCLING SURGE Caterpillar


OPERATION OF BUCKET MAY EXPERIENCE A CYCLING SURGE

Usage:

OPERATION OF BUCKET MAY EXPERIENCE A CYCLING SURGE

CONFIDENTIAL TIBU2660-00

TECHNICAL INFORMATION BULLETIN

April 16, 2003

EXCAVATORS

5110B (AAA1-Up)

5110B L (AAK1-Up)

 

Component Code 5051, 6514

SUBJECT: Operation Of Bucket May Experience A Cycling Surge

PROBLEM:

There have been complaints that an objectionable cyclical surge may occur when the bucket circuit is moved to a fully open or fully close position.

SOLUTION:

When this complaint is experienced in the machines listed, install either a 9G-6403 or 4J-9780 Orifice Plug (1.6 mm (.06 in.) orifice) in the bucket compensator passage (1) as shown in Illustration 1. The orifice plug installed beneath the plug should greatly reduce the bucket surge. An alternative repair can be to drill a 1.6 mm (.06 in.) orifice in a 3D-4603 Plug.

NOTE: Refer to Service Magazine; November 27, 1995; "Various Size Orifice Plugs Available Through Parts Department"; for other orifice sizes. An orifice size smaller that 1.6 mm (.06 inch) may be tried but could result in a slower response time after the bucket control lever is moved.

Illustration 1.
(A) Bucket Valve
(1) Bucket compensator
(2) Orifice Plug

COPYRIGHT 2003 CATERPILLAR
ALL RIGHTS RESERVED

Caterpillar Information System:

224-7252 XT-6 ES HOSE ASSEMBLY WILL NOT FIT CORRECTLY 224-7252 XT-6 ES HOSE ASSEMBLY WILL NOT FIT CORRECTLY
Certain Air Dryers Should be Removed From Dealer Inventory Certain Air Dryers Should be Removed From Dealer Inventory
Additions to Service Maintenance Interval for Suspension Cylinders on Off-Highway Trucks Additions to Service Maintenance Interval for Suspension Cylinders on Off-Highway Trucks
Reroute Oil Supply for Custom Autolube Pump Reroute Oil Supply for Custom Autolube Pump
Surface Cracks Found In 138-7574 Link Bracket Surface Cracks Found In 138-7574 Link Bracket
Cab Mounting Group May Not Assembly Properly Cab Mounting Group May Not Assembly Properly
Water May Leak Into The Cab Or Canopy Water May Leak Into The Cab Or Canopy
Missing Rear Gear Train Idler Shaft Mounting Bolt Seals May Result In Oil Leaks Missing Rear Gear Train Idler Shaft Mounting Bolt Seals May Result In Oil Leaks
Check Orientation Of Hydraulic Oil Filter Base Check Orientation Of Hydraulic Oil Filter Base
Air Cleaner Mounting Band May Loosen And Rattle Air Cleaner Mounting Band May Loosen And Rattle
Machining Premachined Valve Seat Inserts Machining Premachined Valve Seat Inserts
3300 Engine Oil Level Maintenance And High Oil Consumption 3300 Engine Oil Level Maintenance And High Oil Consumption
HYDRAULIC TANK FILLER TUBE STRAINER MAY RUST HYDRAULIC TANK FILLER TUBE STRAINER MAY RUST
Certain Wheel-Tractor Scrapers May Experience Leadking at the Final Drive Oil Drain Hole Certain Wheel-Tractor Scrapers May Experience Leadking at the Final Drive Oil Drain Hole
Some 2P-4472, 7G-0825, and 8P-1656 Clutch Plates May Have Been Shipped Into the Parts System Before Finish Grinding Some 2P-4472, 7G-0825, and 8P-1656 Clutch Plates May Have Been Shipped Into the Parts System Before Finish Grinding
THE WELD BETWEEN THE TOP PLATE AND THE SIDE PLATE BELOW THE STICK BRACKETS MAY CRACK THE WELD BETWEEN THE TOP PLATE AND THE SIDE PLATE BELOW THE STICK BRACKETS MAY CRACK
Some Pumps May Have the Incorrect Actuator Some Pumps May Have the Incorrect Actuator
DISASSEMBLY OF THE STICK CYLINDERS AND OF THE BUCKET CYLINDERS MAY BE DIFFICULT DISASSEMBLY OF THE STICK CYLINDERS AND OF THE BUCKET CYLINDERS MAY BE DIFFICULT
FINAL DRIVE SPINDLE BEARINGS MAY FAIL FINAL DRIVE SPINDLE BEARINGS MAY FAIL
The Fan Guard Mounts May Fail Prematurely on 5110B Excavtors The Fan Guard Mounts May Fail Prematurely on 5110B Excavtors
Proper Orientation of the Rod Yoke Prevents Interference with the Stick During Extension on Some Excavators Proper Orientation of the Rod Yoke Prevents Interference with the Stick During Extension on Some Excavators
Tire Performance Problems On Off Highway Trucks Can Be Prevented Tire Performance Problems On Off Highway Trucks Can Be Prevented
Incorrect Pressure Specification For PiIot System Pressure Test Incorrect Pressure Specification For PiIot System Pressure Test
Check For Correct Operation Of Oil Level Switch Check For Correct Operation Of Oil Level Switch
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.