Turbocharger - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将排油管 (7) 安装到发动机上。 将密封垫和涡轮增压器 (5) 放置在排气歧管顶部,然后安装四根螺栓 (6) 和螺母。
Show/hide table
图 1 | g00537495 |
注: 检查密封垫和 O 型密封圈的状况。 如果密封垫或 O 型密封圈磨损或损坏,则用新零件更换。
- 安装密封垫和两根螺栓 (3) ,将排油管固定到涡轮增压器上。 放置好供油管,然后安装密封垫和两根螺栓 (1) ,将供油管固定到涡轮增压器上。 拧紧螺母 (4) 。
Show/hide table
图 2 | g00537468 |
- 在 3304B 上,使软管滑入到涡轮增压器和连入缸盖的管子中。 拧紧软管卡箍。
- 安装卡箍,将供油管和排油管固定到位,然后安装螺栓 (2) 。
Caterpillar Information System:
3406E and 3456 Generator Set Engines Electric Starting Motor
3406E Generator Set Engines Refill Capacities
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
G3500 Engines Engine Oil and Water Pump Drive - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Assemble
G3606 and G3608 Engines Air Inlet Choke - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Remove
G3500 Engines Engine Oil and Water Pump Drive - Assemble
3406E and 3456 Generator Set Engines Exhaust Manifold
G3500 Engines Engine Air Cleaner Service Indicator - Inspect
G3500 Engines Engine Oil Pan - Assemble
G3606 and G3608 Engines Aftercooler - Install
3116 Truck Engine Cold Weather Operation
3406E Generator Set Engines Control Panel
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Magneto Interface - Remove and Install
G3606 and G3608 Engines Prechamber Check Valve - Remove and Install
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}
3500B Engines Turbocharger
G3606 and G3608 Engines Connecting Rod Bearings - Remove and Install
3500B Engines for Caterpillar Built Power Modules Turbocharger
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Tuning OP-11
3508B Engine for Caterpillar Built Machines Turbocharger