Engine Oil and Water Pump Drive - Disassemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-0520 | Driver Group | 1 |
Start By:
- Remove the engine oil and water pump drive. Refer to Disassembly and Assembly, "Engine Oil and Water Pump Drive - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove O-ring seal (3).
- Remove the bolts and washers (2). Remove rear adapter assembly (4) from shaft assembly (1).
Show/hide table
Illustration 2 g01254536 - Remove O-ring seals (6) and (7) from rear adapter assembly (4).
- Use Tooling (A) and a suitable press to remove bearing (5).
Show/hide table
Illustration 3 g00590612 - Remove bolts (9) from shaft assembly (1). Remove gears (8) and (10) from shaft assembly (1).
Show/hide table
Illustration 4 g00590613 - Remove O-ring seal (13) from front adapter assembly (12).
- Use Tooling (A) and a suitable press to remove bearing (11) from front adapter assembly (12).
Show/hide table
Illustration 1 | g01254535 |
Caterpillar Information System:
G3606 and G3608 Engines Air Inlet Choke - Assemble
G3606 and G3608 Engines Air Inlet Choke - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Remove
G3500 Engines Engine Oil and Water Pump Drive - Assemble
3406E and 3456 Generator Set Engines Exhaust Manifold
G3500 Engines Engine Air Cleaner Service Indicator - Inspect
G3500 Engines Engine Oil Pan - Assemble
G3606 and G3608 Engines Aftercooler - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
G3606 and G3608 Engines Aftercooler - Remove
3406E and 3456 Generator Set Engines Electrical Ground Stud
G3500 Engines Engine Oil Pan - Disassemble
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
3406E Generator Set Engines Refill Capacities
3406E and 3456 Generator Set Engines Electric Starting Motor
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
3116 Truck Engine Cold Weather Operation
3406E Generator Set Engines Control Panel
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Magneto Interface - Remove and Install
G3606 and G3608 Engines Prechamber Check Valve - Remove and Install
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}
3500B Engines Turbocharger