Exhaust Manifold
Show/hide table
Illustration 1 | g00590579 |
Typical example |
Show/hide table
Illustration 2 | g00566220 |
Typical example |
Show/hide table
Illustration 3 | g00566145 |
Tightening sequence |
(1) Locknut
- Tighten the locknuts in the numerical sequence that is shown in Illustration 3 to the following torque. ... 38 ± 5 N·m (28 ± 4 lb ft)
(2) Manifold ends
Apply engine oil to the female ends of the manifolds before assembly. Apply 2P-2333 High Temperature Sealer to the male ends of the manifolds before assembly. Remove excess sealer from the assembled joint.
(3) Stud
-
Apply 5P-3931 Anti-Seize Compound to the threads of the studs that engage the locknuts.
- Tighten the studs in the cylinder head to the following torque. ... 35 ± 5 N·m (26 ± 4 lb ft)
Caterpillar Information System:
G3500 Engines Engine Air Cleaner Service Indicator - Inspect
G3500 Engines Engine Oil Pan - Assemble
G3606 and G3608 Engines Aftercooler - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
G3606 and G3608 Engines Aftercooler - Remove
3406E and 3456 Generator Set Engines Electrical Ground Stud
G3500 Engines Engine Oil Pan - Disassemble
G3500B Engines Fuel Metering Valve Screen - Check
G3606 and G3608 Engines Air Inlet Elbow - Remove and Install
G3500 Engines Engine Oil Pan - Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Fan Drive - Assemble
G3500 Engines Engine Oil Pan - Remove
G3500 Engines Engine Oil and Water Pump Drive - Assemble
G3606 and G3608 Engines Air Inlet Choke - Remove
G3606 and G3608 Engines Air Inlet Choke - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Assemble
G3500 Engines Engine Oil and Water Pump Drive - Disassemble
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
3406E Generator Set Engines Refill Capacities
3406E and 3456 Generator Set Engines Electric Starting Motor
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
3116 Truck Engine Cold Weather Operation
3406E Generator Set Engines Control Panel
G3606 and G3608 Engines Gas Needle Valve - Remove and Install