Air Inlet Choke - Assemble
组装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
图 1 | g00590713 |
- 将轴 (2) 插入阻风门的壳体 (5) 中。
- 安装阻风门板 (4) 。 安装阻风门板时,使安装螺栓 (1) 保持在拧松状态。 安装止推垫圈 (3) 。 安装螺栓。 将螺栓拧紧至扭矩为 47 ± 9 N·m (35 ± 7 lb ft)。 完全关闭阻风门板。 将阻风门板的安装螺栓拧紧至扭矩 12 ± 3 N·m (9 ± 2 lb ft)。
- 安装板和两个螺栓。 将两个螺栓拧紧至扭矩 47 ± 9 N·m (35 ± 7 lb ft)。
- 将阻风门板组装在轴上后,安装调整螺栓直至其与挡板接触。 应再将调整螺栓拧紧 90 度。 将调整螺母拧紧至扭矩 25 ± 6 N·m (18 ± 5 lb ft)。
注: 拧紧锁紧螺母时,调整螺钉不能转动。
End By: 安装进气阻风门。 请参阅 拆解和装配进气阻风门 - 拆, "卸"。
Caterpillar Information System:
G3606 and G3608 Engines Air Inlet Choke - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Remove
G3500 Engines Engine Oil and Water Pump Drive - Assemble
3406E and 3456 Generator Set Engines Exhaust Manifold
G3500 Engines Engine Air Cleaner Service Indicator - Inspect
G3500 Engines Engine Oil Pan - Assemble
G3606 and G3608 Engines Aftercooler - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
G3606 and G3608 Engines Aftercooler - Remove
3406E and 3456 Generator Set Engines Electrical Ground Stud
G3500 Engines Engine Oil Pan - Disassemble
G3500B Engines Fuel Metering Valve Screen - Check
G3500 Engines Engine Oil and Water Pump Drive - Disassemble
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
3406E Generator Set Engines Refill Capacities
3406E and 3456 Generator Set Engines Electric Starting Motor
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
3116 Truck Engine Cold Weather Operation
3406E Generator Set Engines Control Panel
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Magneto Interface - Remove and Install
G3606 and G3608 Engines Prechamber Check Valve - Remove and Install
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}