Magneto Interface - Remove and Install
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
图 1 | g00591055 |
- 断开磁电机接口的电源。
- 断开电气连接 (3) 。
- 断开电气连接 (5) 。
- 卸下两个螺栓 (1) 。
- 重新放好磁电机接口箱 (2) 。
- 卸下四个螺母 (4) 、垫圈、护线圈和接地母线。
- 卸下磁电机接口箱 (2) 。
安装步骤
注: 安装磁电机接口箱时,重新连接接地母线极其重要。
- 安装磁电机接口箱 (2) 。
- 安装四个螺母 (4) 、垫圈、护线圈和接地母线。
- 安装两个螺栓 (1) 。
- 连接电气连接 (5) 。
- 连接电气连接 (3) 。
- 连接磁电机接口的电源。
Caterpillar Information System:
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3406E Generator Set Engines Control Panel
3116 Truck Engine Cold Weather Operation
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
3406E and 3456 Generator Set Engines Electric Starting Motor
3406E Generator Set Engines Refill Capacities
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
G3500 Engines Engine Oil and Water Pump Drive - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Assemble
G3606 and G3608 Engines Air Inlet Choke - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Remove
G3606 and G3608 Engines Prechamber Check Valve - Remove and Install
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}
3500B Engines Turbocharger
G3606 and G3608 Engines Connecting Rod Bearings - Remove and Install
3500B Engines for Caterpillar Built Power Modules Turbocharger
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Tuning OP-11
3508B Engine for Caterpillar Built Machines Turbocharger
12H, 140H and 160H Motor Graders Power Train Final Drive - Disassemble
3406E Generator Set Engines Model View Illustrations
3500 Engines Exhaust Manifold
120H and 135H Motor Graders Power Train Final Drive - Assemble
G3500 Engines Engine Oil and Water Pump Drive - Remove