Air Inlet Choke - Remove
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
注: 将开口盖上以防污染。
Show/hide table
图 1 | g00590678 |
- 卸下螺栓 (3) ,以便断开阻风门和阻风门执行器的连接件。
- 拧松操纵杆的螺栓。 从轴 (5) 上卸下操纵杆 (6) 。
- 卸下八个螺栓 (2) 。
- 卸下八个螺栓 (1) 。
- 卸下壳体组件 (4) 和垫片。 检查密封垫有无损坏。 必要时更换密封垫。
安装步骤
- 检查密封垫有无损坏。 必要时更换密封垫。 安装壳体组件 (4) 和垫片。
- 安装八个螺栓 (2) 。
- 安装八个螺栓 (1) 。
- 将操纵杆 (6) 安装在轴 (5) 上。 拧紧操纵杆的螺栓。
- 安装螺栓 (3) 以连接阻风门和阻风门执行器的连接件。
Caterpillar Information System:
G3500 Engines Engine Oil and Water Pump Drive - Assemble
3406E and 3456 Generator Set Engines Exhaust Manifold
G3500 Engines Engine Air Cleaner Service Indicator - Inspect
G3500 Engines Engine Oil Pan - Assemble
G3606 and G3608 Engines Aftercooler - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
G3606 and G3608 Engines Aftercooler - Remove
3406E and 3456 Generator Set Engines Electrical Ground Stud
G3500 Engines Engine Oil Pan - Disassemble
G3500B Engines Fuel Metering Valve Screen - Check
G3606 and G3608 Engines Air Inlet Elbow - Remove and Install
G3500 Engines Engine Oil Pan - Install
G3606 and G3608 Engines Air Inlet Choke - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Assemble
G3500 Engines Engine Oil and Water Pump Drive - Disassemble
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
3406E Generator Set Engines Refill Capacities
3406E and 3456 Generator Set Engines Electric Starting Motor
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
3116 Truck Engine Cold Weather Operation
3406E Generator Set Engines Control Panel
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Magneto Interface - Remove and Install