Prechamber Check Valve - Remove and Install
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
图 1 | g00591121 |
Show/hide table
图 2 | g00591123 |
- 拆下气门室盖。
- 卸下螺塞 (1) 和主体组件 (2) 上的密封件。
注: 继续拆解步骤前,请清除螺塞 (1) 顶部的机油。
- 卸下预燃室单向阀 (3) 和垫片。 从预燃室单向阀上卸下 O 形密封圈。
安装步骤
- 将一层薄 5N-5561 硅润滑剂 涂敷在 O 形密封圈外侧。
- 安装预燃室单向阀 (3) 。 将预燃室单向阀拧紧至扭矩 115 ± 15 N·m (85 ± 11 lb ft)。
- 将螺塞 (1) 和密封件安装在主体组件 (2) 内。 将螺塞拧紧至扭矩 34 ± 7 N·m (25 ± 5 lb ft)。
- 安装气门室盖。
Caterpillar Information System:
G3606 and G3608 Engines Magneto Interface - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
3406E Generator Set Engines Control Panel
3116 Truck Engine Cold Weather Operation
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Install
3406E and 3456 Generator Set Engines Electric Starting Motor
3406E Generator Set Engines Refill Capacities
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Remove
G3500 Engines Engine Oil and Water Pump Drive - Disassemble
G3606 and G3608 Engines Air Inlet Choke - Assemble
G3606 and G3608 Engines Air Inlet Choke - Disassemble
Installation of 185-7733 Sensor Kit {1928} Installation of 185-7733 Sensor Kit {1928}
3500B Engines Turbocharger
G3606 and G3608 Engines Connecting Rod Bearings - Remove and Install
3500B Engines for Caterpillar Built Power Modules Turbocharger
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Tuning OP-11
3508B Engine for Caterpillar Built Machines Turbocharger
12H, 140H and 160H Motor Graders Power Train Final Drive - Disassemble
3406E Generator Set Engines Model View Illustrations
3500 Engines Exhaust Manifold
120H and 135H Motor Graders Power Train Final Drive - Assemble
G3500 Engines Engine Oil and Water Pump Drive - Remove
G3500 Engines Engine Oil and Water Pump Drive - Install