Air Silencer - Remove and Install
拆卸步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
 |
断开储气罐上的供气。 从空气起动系统中排放压缩空气。 压缩空气的突然释放可能会导致人身伤害。 |
Show/hide table
 | |
| 图 1 | g00589675 |
- 确保断开供气。 确保气压从空气起动系统中排出。
- 卸下四个螺栓 (1) 。
- 卸下空气消音器 (2) 和垫片。 请检查垫片是否损坏。 如有必要，更换垫片。
安装步骤
- 请检查垫片是否损坏。 如有必要，更换垫片。 安装空气消音器 (2) 和垫片。
- 安装四个螺栓 (1) 。
- 接通气源。
- 检查系统是否出现泄漏。
Caterpillar Information System:
3116 Truck Engine Fuel Injection Timing - Check
G3500B Engines Overhaul (Top End)
G3500B Engines Overhaul (Major)
G3500 Engines Flywheel Housing - Install
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Viewing OP2-3
G3500 Engines Overhaul (In-Frame)
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Relief Valve (Travel Motor) - Test and Adjust
G3606 and G3608 Engines Fuel Shutoff Solenoid - Remove and Install
3116 Truck Engine Engine Oil and Filter - Change
G3606 and G3608 Engines Crankcase Pressure Sensor - Remove and Install
3612 and 3616 Engines Temperature Contactor
G3500B Engines Ignition System Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
3116 Truck Engine Fuel Inlet Screen - Clean/Inspect/Replace
3406E and 3456 Generator Set Engines Engine Oil Pan
G3500 Engines Flywheel - Remove and Install
3116 Truck Engine Fuel Tank Water and Sediment - Drain
3608 Engine Air Lubricator - Remove and Install
3116 Truck Engine Walk-Around Inspection
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Fan Drive - Disassemble
G3500 Engines Vibration Damper - Remove and Install
G3606 and G3608 Engines Air Valve - Remove and Install
G3606 and G3608 Engines Generator - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Engine Oil Sequence Valves - Remove and Install