Fuel Shutoff Solenoid - Remove and Install
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 关闭燃油切断电磁阀 (2) 的供油。 断开燃油进油口 (4) 的供油。
- 断开电气连接 (1) 。
- 卸下两个 C-夹 (5) 。
- 卸下支架 (7) 。
- 从弯头 (3) 卸下燃油切断电磁阀。 将组件移至合适的工作台。
- 从燃油切断电磁阀 (2) 卸下两个螺纹接头 (6) 。
- 连接电气连接 (1) 。
安装步骤
- 从燃油切断电磁阀 (2) 安装两个螺纹接头 (6) 。
- 从弯头 (3) 安装燃油切断电磁阀。
- 安装支架 (7) 。
- 卸下两个 C-夹 (5) 。
- 连接燃油进油口 (4) 的供油。 打开燃油切断电磁阀 (2) 的供油。
Caterpillar Information System:
3116 Truck Engine Engine Oil and Filter - Change
G3606 and G3608 Engines Crankcase Pressure Sensor - Remove and Install
3612 and 3616 Engines Temperature Contactor
G3500B Engines Ignition System Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
G3500B Engines Fuel System Fuel Filter Differential Pressure - Check
The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471} The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471}
3116 Truck Engine Engine Oil Level - Check
3116 Truck Engine Engine Crankcase Breather - Clean
3408E and 3412E Engines for Caterpillar Built Machines Electric Starting System - Test
G3606 and G3608 Engines Water Lines - Remove and Install
3054 Truck Engine Reference Material
G3500 Engines Flywheel Housing - Remove
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Relief Valve (Travel Motor) - Test and Adjust
G3500 Engines Overhaul (In-Frame)
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Viewing OP2-3
G3500 Engines Flywheel Housing - Install
G3500B Engines Overhaul (Major)
G3500B Engines Overhaul (Top End)
3116 Truck Engine Fuel Injection Timing - Check
G3606 and G3608 Engines Air Silencer - Remove and Install
3116 Truck Engine Fuel Inlet Screen - Clean/Inspect/Replace
3406E and 3456 Generator Set Engines Engine Oil Pan
G3500 Engines Flywheel - Remove and Install
3116 Truck Engine Fuel Tank Water and Sediment - Drain