Water Lines - Remove and Install
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将水从系统中排出。
- 卸下四个螺栓 (4) 。
Show/hide table
图 1 | g00588663 |
- 卸下螺栓 (1) 和护圈。 卸下两个夹子 (3) 。
- 卸下弯头 (2) 。
- 卸下管 (5) 。
- 卸下十个螺栓 (6) 。
Show/hide table
图 2 | g00588665 |
- 卸下弯头 (7) 和垫片。
- 卸下其余螺栓、护圈、管和弯头。
注: 检查所有垫片和 O 形密封圈是否损坏。 如有必要,更换垫片和/或 O 形密封圈。
安装步骤
注: 检查所有垫片和 O 形密封圈是否损坏。 如有必要,更换垫片和/或 O 形密封圈。
注: 安装前使用乙二醇润滑所有密封件。
- 安装弯头 (7) 和垫片。
- 安装十个螺栓 (6) 。
- 安装管 (5) 。
- 安装弯头 (2) 。
- 安装螺栓 (1) 和护圈。 安装两个夹子 (3) 。
- 安装四个螺栓 (4) 。
- 安装其余螺栓、护圈、管和弯头。
- 将水系统注水至正确的水位。 关于正确步骤,请查看操作和维护手册。
Caterpillar Information System:
3054 Truck Engine Reference Material
G3500 Engines Flywheel Housing - Remove
G3606 and G3608 Engines Water Temperature Regulator and Housing - Remove
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Jacket Water Heater
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Travel Motor - Test
3126 Truck Engine (Military) Fuel Recommendations
G3500 Engines Crankshaft Front Seal and Wear Sleeve - Install
3126 Truck Engine (Military) Lubricant Information
797 Off-Highway Truck Power Train Solenoid Valve (Final Drive Oil Diverter)
3116 Truck Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
G3500 Engines Crankshaft Front Seal and Wear Sleeve - Remove
3116 Truck Engine Belt - Inspect
3408E and 3412E Engines for Caterpillar Built Machines Electric Starting System - Test
3116 Truck Engine Engine Crankcase Breather - Clean
3116 Truck Engine Engine Oil Level - Check
The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471} The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471}
G3500B Engines Fuel System Fuel Filter Differential Pressure - Check
G3500B Engines Ignition System Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
3612 and 3616 Engines Temperature Contactor
G3606 and G3608 Engines Crankcase Pressure Sensor - Remove and Install
3116 Truck Engine Engine Oil and Filter - Change
G3606 and G3608 Engines Fuel Shutoff Solenoid - Remove and Install
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Relief Valve (Travel Motor) - Test and Adjust
G3500 Engines Overhaul (In-Frame)