Engine Oil Pan
Show/hide table
 | |
| Illustration 1 | g01094010 |
(1) Bolt
- Tighten the bolts to the following torque. ... 47 ± 9 N·m (35 ± 7 lb ft)
(2) Drain plug
- Tighten the drain plugs to the following torque. ... 70 ± 15 N·m (52 ± 11 lb ft)
Caterpillar Information System:
3116 Truck Engine Fuel Inlet Screen - Clean/Inspect/Replace
G3606 and G3608 Engines Air Silencer - Remove and Install
3116 Truck Engine Fuel Injection Timing - Check
G3500B Engines Overhaul (Top End)
G3500B Engines Overhaul (Major)
G3500 Engines Flywheel Housing - Install
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Viewing OP2-3
G3500 Engines Overhaul (In-Frame)
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Relief Valve (Travel Motor) - Test and Adjust
G3606 and G3608 Engines Fuel Shutoff Solenoid - Remove and Install
3116 Truck Engine Engine Oil and Filter - Change
G3606 and G3608 Engines Crankcase Pressure Sensor - Remove and Install
G3500 Engines Flywheel - Remove and Install
3116 Truck Engine Fuel Tank Water and Sediment - Drain
3608 Engine Air Lubricator - Remove and Install
3116 Truck Engine Walk-Around Inspection
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Fan Drive - Disassemble
G3500 Engines Vibration Damper - Remove and Install
G3606 and G3608 Engines Air Valve - Remove and Install
G3606 and G3608 Engines Generator - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Engine Oil Sequence Valves - Remove and Install
120H and 135H Motor Graders Hydraulic and Steering System Gerotor Motor (Circle Drive)
3406E and 3456 Generator Set Engines Flywheel Housing