Parallel Setpoint Viewing OP2-3
OP2-3 是并联设定点查看的选项。 并联设定点定义了让频率和相位精确匹配的各种参数。 这些从 P301 至 P314 的设定点都是可编程设定的。 有关这些设定点的说明,请参阅测试和调整, "并联设定点编程 OP5-3"。
Caterpillar Information System:
G3500 Engines Overhaul (In-Frame)
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Relief Valve (Travel Motor) - Test and Adjust
G3606 and G3608 Engines Fuel Shutoff Solenoid - Remove and Install
3116 Truck Engine Engine Oil and Filter - Change
G3606 and G3608 Engines Crankcase Pressure Sensor - Remove and Install
3612 and 3616 Engines Temperature Contactor
G3500B Engines Ignition System Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
G3500B Engines Fuel System Fuel Filter Differential Pressure - Check
The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471} The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471}
3116 Truck Engine Engine Oil Level - Check
3116 Truck Engine Engine Crankcase Breather - Clean
3408E and 3412E Engines for Caterpillar Built Machines Electric Starting System - Test
G3500 Engines Flywheel Housing - Install
G3500B Engines Overhaul (Major)
G3500B Engines Overhaul (Top End)
3116 Truck Engine Fuel Injection Timing - Check
G3606 and G3608 Engines Air Silencer - Remove and Install
3116 Truck Engine Fuel Inlet Screen - Clean/Inspect/Replace
3406E and 3456 Generator Set Engines Engine Oil Pan
G3500 Engines Flywheel - Remove and Install
3116 Truck Engine Fuel Tank Water and Sediment - Drain
3608 Engine Air Lubricator - Remove and Install
3116 Truck Engine Walk-Around Inspection
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install