Flywheel
Show/hide table
| |
| Illustration 1 | g01437629 |
|
(1) Flywheel ring gear
(2) Flywheel | |
Refer to the Testing And Adjusting, "Basic Block" topic for the proper procedure to check flywheel runout.
(3) Bolt
- Tighten the bolts to the following torque. ...
300 ± 40 N·m (220 ± 30 lb ft)
Apply 7M-7456 Compound to the bolt threads.
Caterpillar Information System:
3176C and 3196 Industrial Engines Flywheel
3500B Locomotive Engines Refill Capacities
C175-16 Locomotive Engines Engine Rating Definitions
3406E and 3456 Industrial Engines Alternator Mounting
3176C and 3196 Industrial Engines Engine Support (Front)
3176C and 3196 Engines for Caterpillar Built Machines Gear Group (Front)
3512C HD Locomotive Engine Manual Stop Procedure
3176C and 3196 Engines for Caterpillar Built Machines Housing (Front)
3406E and 3456 Industrial Engines Jacket Water Heater
3176C and 3196 Industrial Engines Piston and Rings
3500B Locomotive Engines Emergency Stopping
C175-16 Locomotive Engine Fuel Conservation Practices
3500B Locomotive Engines Monitoring System
3406E and 3456 Industrial Engines Fuel Filter Base
3406E Truck Engine Gear Group (Front)
3406E and 3456 Industrial Engines Housing (Front)
CPT372 Truck Mounted Pumper Fuel Related Components in Cold Weather
3406E and 3456 Industrial Engines Accessory Drive
Electronic Modular Control Panel II+ (EMCP II+) Sensors
3500 and 3500B Engines Alarms and Shutoffs
3054E and 3056E Industrial Engines Electronics Grounding Stud - Inspect/Clean/Tighten
Electronic Modular Control Panel II+ (EMCP II+) Instrument Panel - For 3508, 3512, and 3516 MUI Engines (Including Paralleling) and 3412C PEEC Engines With Paralleling
3408E and 3412E Industrial Engines Fuel System - Prime
3408E and 3412E Industrial Engines Fuel System Secondary Filter - Replace