Engine To Engine Wiring Harness Caterpillar


Engine To Engine Wiring Harness

Usage:

ENGINES3126B (9ZF, 3GS),
3176C (6BW),
3196 (2XR),
3406E (9WR),
3412E (9KS, 5PW) MARINE ENGINES

Problem:

The 189-5599 Engine To Engine Wiring Harness Assembly (30 ft) and the 198-9159 Engine To Engine Wiring Harness Assembly (15 ft) for the OEM wiring harness has been made incorrectly by the supplier. The primary throttle, secondary throttle, synchronization input 1, and synchronization input 2 wires are not installed in the correct pin location in the 12-pin connector. The throttle synchronization will not work correctly unless the engine to engine harness is changed.

Solution:

Use multimeter to check the wiring connections on the engine to engine wiring harness assembly. The table identifies the circuits to check. If the connection in the harness that is being tested does not match the table, change the pins to match the table below.

NOTE: Connector A is identified by the label "Cat Data Link End".

COPYRIGHT 2001 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Engine Oil Cooler Engine Oil Cooler
Paralleling Generators To Utility Substations Paralleling Generators To Utility Substations
3306/3406 Correction of �Overspeed at Start-up� complaint on standby generator set engines 3306/3406 Correction of �Overspeed at Start-up� complaint on standby generator set engines
Slow Acceleration Slow Acceleration
Loss Of The Desired Speed Signal During Earth Fault Test Loss Of The Desired Speed Signal During Earth Fault Test
1495-2 Diagnostic Codes May Become Active After Flashing The Latest 3500B Software 1495-2 Diagnostic Codes May Become Active After Flashing The Latest 3500B Software
Push Rod Wear Push Rod Wear
Possible De-Aerator Housing Blockage Possible De-Aerator Housing Blockage
Engine Operating Software Engine Operating Software
Cooling System Plugs Cooling System Plugs
7S-5106 Chuck May Have Two Different Thread Engagements 7S-5106 Chuck May Have Two Different Thread Engagements
Connecting Rod Bearings Connecting Rod Bearings
A Starting Problem May Be A Result Of A Fuel Tank And Base Group Problem A Starting Problem May Be A Result Of A Fuel Tank And Base Group Problem
Air Pipe Between The Turbocharger Air Outlet And The Aftercooler Air Inlet Air Pipe Between The Turbocharger Air Outlet And The Aftercooler Air Inlet
BRIDGE RECTIFIER TEST BRIDGE RECTIFIER TEST
Incorrect Assembly Instructions For Rod Seals In Hydraulic Cylinders Incorrect Assembly Instructions For Rod Seals In Hydraulic Cylinders
Flywheel Housing Failures Flywheel Housing Failures
168-7823 Time Delay Relay In The Engine Supervisory System (ESS) 168-7823 Time Delay Relay In The Engine Supervisory System (ESS)
Slow Vessel Mode (550 RPM) Slow Vessel Mode (550 RPM)
Air Inlet Heater Air Inlet Heater
3500B Engines That Are Used On EPG Applications And Have An Emergency Stop Box Are Wired Incorrectly 3500B Engines That Are Used On EPG Applications And Have An Emergency Stop Box Are Wired Incorrectly
Lack Of Power, Engine Speed Does Not Return To Rated Or High Idle Speed Lack Of Power, Engine Speed Does Not Return To Rated Or High Idle Speed
Air Inlet Heater Air Inlet Heater
Low Level Leakage Experienced With The New Caterpillar Yellow Rod Seals Low Level Leakage Experienced With The New Caterpillar Yellow Rod Seals
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.