1991/04/22 Caterpillar


6L7896 Starting Motor (24V DC) Is No Longer Available From Caterpillar{1453}

Usage:


D330C, 3304 ( 02B, 04B );
D333C, 3306 ( 09A, 23C, 66D, 70R );
D334 ( 92B );
D336 ( 55B ) Industrial Engines

The 6L7896 Starting Motor has been changed from status CRB (canceled replaced by) 4N3181 Motor group to CAN (canceled). The 4N3181 is not a replacement for 6L7896. Due to the low service requirements for 6L7896, Caterpillar will not release a service replacement motor. However, there is a source where the customer can obtain the 6L7896 Starting Motor. The motor can be ordered under its obsolete Delco Remy part number 1113946 from:

Consolidated Sales International
P.O. Box 117
Hialeah, Florida 33011-0117
Telephone: (309) 634-5183

Caterpillar Information System:

1991/04/22 Procedure To Set Voltage Droop On SR 4 Generators With VR3 Voltage Regulators Using Resistive Load Bank{4475,4467}
1991/04/22 Procedure For Applying 1U8846 Gasket Maker{0648,7555}
1991/04/15 New Oil Filter Element Assembly Used In Oil Filter Groups{1318}
1991/04/15 New Shaft Bracket And Oil Supply Plug Used In Rocker Valve Shaft Assembly{1102,7553}
1991/04/15 New Auxiliary Water Pump Used; New Chart Lists Auxiliary Water Pump Group Numbers, Pulley Sizes, And Drive Belts{1371,1357,1384}
1991/04/15 New Specification For Transmission And Drive Train Oil (TDTO){0645,3004,3150,3179}
1991/04/15 Simplified Battery Test Procedure SEHS7633-02 And Battery Test Sheet SEHS9326 Available{1401}
1991/04/08 Remote Mounted Pressure Sensor Used In Temperature And Pressure Control Group In Electronic Modular Control Panel (ECMP){4490}
1991/04/08 New Carburetor Control Leakage Improves Idle Stability{1266}
1991/04/08 New Bolt Improves Retention Of Backplate To Housing Assembly In Turbocharger Cartridge Groups{1052,1053,1056,7553}
1991/04/08 Two Different Air Inlet Heater Control Modules Available{1090,1087,1058}
1991/04/01 Continuous Single Cylinder Misfire When Engine Is Under Load {1552}
1991/04/22 New Diagnostic Code 28 "Check Throttle Sensor Adjustment" Is On 1991 Engines{1900}
1991/04/22 Special Instruction, SEHS9340, Gives Jacket Water Heater Installation Procedures{1383}
1991/04/22 Improved Turbocharger Water Lines Group Eliminates Tube Cracking And Coolant Loss{1380,1052}
1991/04/22 Corrections For Systems Operation, Troubleshooting, And Specifications For 2301 Electric Governors For Generator Set And Industrial Engines, SENR2928-01{1289}
1991/04/29 Remove And Clean Flame Arrestors At Each Top End Overhaul{1058,1087}
1991/04/29 How To Obtain Military Manuals On Caterpillar Equipment{0374,0375}
1991/04/29 Inlet Air Temperature Sensor Added And Fuel Pressure Sensor Removed From Engine Control System{1900}
1991/05/06 Summary Of Bucket Ground Engaging Tools That Are Available For Parts Service{6800}
1991/05/06 Undersized Crankshaft And Bearings Available For 3176 Truck Engines{1202,1230}
1991/05/06 Oversize Main Bearings Used In Remanufactured Engines Are Also Available For Parts Service{1203}
1991/05/06 New Drain Plug And O-ring Seal Used In Oil Pan Groups{1302,7553,7555}
1991/05/06 New Adjustment Values For Differential Pressure (Wastegate) Regulator{1076}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.