Cab Filter (Recirculation) - Clean/Inspect/Replace
The recirculation filter is located to the left of the operator seat.
- Remove the cover that is over the recirculation filter. Remove the filter element.
Show/hide table
Illustration 1 | g02664862 |
- The filter element can be cleaned by using compressed air. Use a maximum air pressure of 205 kPa (30 psi). Direct the air from the clean side to the dirty side.
- Look through the filter toward a bright light. Inspect the element for damage. Inspect the gaskets for damage. Replace damaged filters.
- Install the filter element.
Note: Clean the filters more often in dusty conditions.
Caterpillar Information System:
2470C, 2570C and 2670C Wheel Feller Bunchers IQAN Monitoring ; Control System Service Tools
SH-56B Felling Head Felling Head Accumulator Arm - Assemble
422F, 428F, 432F, 434F and 444F Backhoe Loaders Cab Filter (Fresh Air) - Clean/Inspect/Replace
2470C, 2570C and 2670C Wheel Feller Bunchers IQAN Monitoring ; Control System Change Language
SH-56B Felling Head Felling Head Accumulator Arm - Disassemble
2014/07/21 Optional Mirror Extensions for Heated and Non-Heated Mirrors are now Available on Certain M Series and M Series 2 Motor Graders {7319}
SH-56B Felling Head Felling Head Grapple Arm Spring - Remove and Install
422F, 428F, 432F, 434F and 444F Backhoe Loaders Stopping the Engine if an Electrical Malfunction Occurs
2011/08/22 A New Foot Support is Available for Certain M and M Series 2 Motor Graders {7301}
428F, 432F, 434F and 444F Backhoe Loaders Sideshift Control
428F, 432F, 434F and 444F Backhoe Loaders Stabilizer Control
2011/09/06 A New Rear Window Shade is Available for Certain M Series Motor Graders {7301}
735B, 740B and 740B EJECTOR Articulated Trucks Power Train Parking Brake - Remove and Install
422F, 428F, 432F, 434F and 444F Backhoe Loaders Cooling System Coolant (ELC) - Change
422F, 428F, 432F, 434F and 444F Backhoe Loaders Cooling System Coolant Level - Check
773G and 775G Quarry Trucks Chassis Electronic Control System MID 087 - CID 0247 - FMI 09
422F, 428F, 432F, 434F and 444F Backhoe Loaders Cooling System Coolant Sample (Level 1) - Obtain
422F, 428F, 432F, 434F and 444F Backhoe Loaders Cooling System Coolant Sample (Level 2) - Obtain
SH-56B Felling Head Felling Head Grapple Arm Spring - Disassemble
R1300G Load Haul Dump Cooling System Level - Check
R1300G Load Haul Dump Cooling System Coolant (DEAC) - Change
C13, C15, and C18 Tier 4 Final Engines Cylinder Head Valves
R1300G Load Haul Dump Cooling System Coolant Extender (ELC) - Add
966H Wheel Loader and 972H Wheel Loader Electrohydraulic System Pilot Oil Accumulator (Dead Engine, Lift Arm Lower) - Test and Charge