Fuel System Primary Filter - Clean/Inspect/Replace
Show/hide table
渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将起动开关断开。 应立即将溅溢的燃油清除干净。 |
Show/hide table
注意 |
---|
不要让脏物进入燃油系统。 彻底清洁将要拆开的燃油系统部件的周围区域。 在拆开的燃油系统部件上安放适当的盖。 |
Show/hide table
注意 |
---|
不要使用工具来拆下燃油滤清器。 试图使用滤清器扳手或滤清器拆卸带来拆下燃油滤清器会损坏锁环。 |
- 在燃油滤清器 (1) 下面放置一个托盘,以便盛装可能溢出的燃油。 有燃油溢出要立即清理掉。
Show/hide table
图 1 | g01454125 |
- 清洁燃油滤清器组件的外部。 打开燃油滤清器底部的排放口 (4) 。 将滤芯中的燃油和水排放到一个适当的容器中。
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修发动机时,请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前,要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品,请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
- 握住滤芯,按逆时针方向转动锁环 (2) 。 卸下锁环 (2) 。 用旧的滤清器芯应卸下,弃置不用。
- 从滤芯上卸下沉淀杯 (3) 。
- 彻底清洁沉淀杯 (3) 。 检查 O 型密封圈。 如有必要,安装新的O型密封圈。
- 将沉淀杯安装到新滤芯上。 用手拧紧沉淀杯。
注: 手拧是应采用的唯一方法。
- 确保滤清器底座清洁。 将新滤芯完全推入滤清器底座内。
Show/hide table
注意 |
---|
安装燃油滤清器之前不要在其中注入燃油。 污染的燃油会加速燃油系统部件的磨损。 |
- 握住滤芯。 装上锁环 (2) 。 顺时针转动锁环以便将滤芯固定到滤清器底座上。
注: 如果前面的操作中卸下了尼龙嵌件,则将其装上并安装盖子。
- 为燃油系统充油。 更多相关信息,请参阅操作和保养手册, "燃油系统 - 充油"。
Caterpillar Information System:
AP600D and BG600D Asphalt Pavers Fuel System Filter (Washdown) - Clean
AP600D and BG600D Asphalt Pavers Fuel System - Prime
Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091} Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091}
854K Wheel Dozer and 992K Wheel Loader Power Train Electronic Control Module (ECM) - Flash Program
C27 and C32 Engines for Caterpillar Built Machines Switch Circuits - Test
AS2252C Asphalt Screed Gear Motor (Vibratory - Main) - Install
AS2252C Asphalt Screed Gear Motor (Vibratory - Main) - Remove
AS2252C Asphalt Screed Flow Divider Valve - Remove and Install
416E, 420E and 430E Backhoe Loaders Transmission (Autoshift) Transmission and Torque Converter - Test
C27 and C32 Engines for Caterpillar Built Machines Compression Brake Solenoid Circuit - Test
AP555E and BG555E Asphalt Pavers Machine Systems Feeder Drive Shaft (Drag)
C4.4 Industrial Engine Accessory Drive - Install
AP600D and BG600D Asphalt Pavers Fuel System Secondary Filter - Replace
AP500E and BG500E Asphalt Pavers Machine Systems Metering Pump (Steering)
CW34 Pneumatic Compactor Battery or Battery Cable - Inspect/Replace
AP600D and BG600D Asphalt Pavers Machine Systems Hydraulic Cylinder (Steering)
CB22, CB24, CB32 and CC24 Vibratory Compactor Air Cleaner - Remove and Install
CB22, CB24, CB32 and CC24 Vibratory Compactor Alternator - Remove and Install
CB22, CB24, CB32 and CC24 Vibratory Compactor Electric Starting Motor - Remove and Install
CB22, CB24, CB32 and CC24 Vibratory Compactor Battery - Remove and Install
AS2252C Asphalt Screed Vibratory Group (Main) - Remove
AS2252C Asphalt Screed Vibratory Group (Main) - Install
AS2252C Asphalt Screed Vibratory Group (Extender) - Remove
AS2252C Asphalt Screed Vibratory Group (Extender) - Install